Phantom studies demonstrated superior resolution and noise properties for the Sharp and UHR modes relative to the standard Macro mode and patient images demonstrated the potential benefit of these scan modes for clinical practice.

Dual energy CT (DECT) measures the object of interest using two different x-ray spectra in order to provide energy-selective CT images or in order to get the material decomposition of the object. Today, two decomposition techniques are known. Image-based DECT uses linear combinations of reconstructed images to get an image that contains material-selective DECT information. Rawdata-based DECT correctly treats the available information by passing the rawdata through a decomposition function that uses information from both rawdata sets to create DECT specific (e.g., material-selective) rawdata. Then the image reconstruction yields material-selective images. Rawdata-based image decomposition generally obtains better image quality; however, it needs matched rawdata sets. This means that physically the same lines need to be measured for each spectrum. In today's CT scanners, this is not the case. The authors propose a new image-based method to combine mismatched rawdata sets for DECT information. The method allows for implementation in a scanner's rawdata precorrection pipeline or may be used in image domain. They compare the ability of the three methods (image-based standard method, proposed method, and rawdata-based standard method) to perform material decomposition and to provide monochromatic images. Thereby they use typical clinical and preclinical scanner arrangements including circular cone-beam CT and spiral CT. The proposed method is found to perform better than the image-based standard method and is inferior to the rawdata-based method. However, the proposed method can be used with the frequent case of mismatched data sets that exclude rawdata-based methods.

At matched CT scan protocol settings and identical image reconstruction parameters, the PCD yields superior in-stent lumen delineation of coronary artery stents as compared with conventional EID arrays.

The purpose of this study was to develop and evaluate the hybrid scatter correction algorithm (HSC) for CT imaging. Therefore, two established ways to perform scatter correction, i.e. physical scatter correction based on Monte Carlo simulations and a convolution-based scatter correction algorithm, were combined in order to perform an object-dependent, fast and accurate scatter correction. Based on a reconstructed CT volume, patient-specific scatter intensity is estimated by a coarse Monte Carlo simulation that uses a reduced amount of simulated photons in order to reduce the simulation time. To further speed up the Monte Carlo scatter estimation, scatter intensities are simulated only for a fraction of all projections. In a second step, the high noise estimate of the scatter intensity is used to calibrate the open parameters in a convolution-based algorithm which is then used to correct measured intensities for scatter. Furthermore, the scatter-corrected intensities are used in order to reconstruct a scatter-corrected CT volume data set. To evaluate the scatter reduction potential of HSC, we conducted simulations in a clinical CT geometry and measurements with a flat detector CT system. In the simulation study, HSC-corrected images were compared to scatter-free reference images. For the measurements, no scatter-free reference image was available. Therefore, we used an image corrected with a low-noise Monte Carlo simulation as a reference. The results show that the HSC can significantly reduce scatter artifacts. Compared to the reference images, the error due to scatter artifacts decreased from 100% for uncorrected images to a value below 20% for HSC-corrected images for both the clinical (simulated data) and the flat detector CT geometry (measurement). Compared to a low-noise Monte Carlo simulation, with the HSC the number of photon histories can be reduced by about a factor of 100 per projection without losing correction accuracy. Furthermore, it was sufficient to calibrate the parameters in the convolution model at an angular increment of about 20°. The reduction of the simulated photon histories together with the reduced amount of simulated Monte Carlo scatter projections decreased the total runtime of the scatter correction by about two orders of magnitude for the cases investigated here when using the HSC instead of a low-noise Monte Carlo simulation for scatter correction.