ABSTRACT:The viscosity as a function of concentration for xanthan gum in both salt-free solution and in 50 mM NaCl is measured and compared with a scaling theory for polyelectrolytes. In general, the zero shear rate viscosity and the degree of shear thinning increase with polymer concentration. In addition, shear thinning was observed in the dilute regime in both solvents. In salt-free solution, four concentration regimes of viscosity scaling and three associated critical concentrations were observed (c* % 70 ppm, c e % 400 ppm, and c D % 2000 ppm). In salt solution, only three concentration regimes and two critical concentrations were observed (c* % 200 ppm and c e % 800 ppm). In the presence of salt, the polymer chain structure collapses and occupies much less space resulting in higher values of the critical concentrations. The observed viscosity-concentration scaling is in very good agreement with theory in the semidilute unentangled and semidilute entangled regimes in both salt-free and 50 mM NaCl solution.

No abstract

Anion exchange membrane fuel cells (AEMFCs) have attracted extensive attention in the recent years, primarily due to the distinct advantage potentials they have over the mainstream proton exchange membrane fuel cells. The anion exchange membrane (AEM) is the key component of AEMFC systems. Due to the unique characteristics of water management in AEMFCs, understanding the water mobility through AEMs is key for this technology, as it significantly affects (and limits) overall cell performances. This work presents a study of the equilibrium state and kinetics of water uptake (WU) for AEMs exposed to vapor source H2O. We investigate different AEMs that exhibit diverse water uptake behaviors. AEMs containing different backbones (fluorinated and hydrocarbon-based backbones) and different functional groups (various cations as part of the backbone or as pendant groups) were studied. Equilibrium WU isotherms are measured and fitted by the Park model. The influence of relative humidity and temperature is also studied for both equilibrium and dynamic WU. A characteristic time constant is used to describe WU kinetics during the H2O sorption process. To the best of our knowledge, this is the first time that WU kinetics has been thoroughly investigated on AEMs containing different backbones and cationic functional groups. The method and analysis described in this work provides critical insights to assist with the design of the next generation anion conducting polymer electrolytes and membranes for use in advanced, high-performance AEMFCs.

Effective and efficient breakdown of lignocellulosic biomass remains a primary barrier for its use as a feedstock for renewable transportation fuels. A more detailed understanding of the material properties of biomass slurries during conversion is needed to design cost-effective conversion processes. A series of enzymatic saccharification experiments were performed with dilute acid pretreated corn stover at initial insoluble solids loadings of 20% by mass, during which the concentration of particulate solids and the rheological property yield stress (tau(y)) of the slurries were measured. The saccharified stover liquefies to the point of being pourable (tau(y)

The addition of positively charged, 30 nm diameter silica nanoparticles to cationic wormlike micellar solutions of cetyltrimethylammonium bromide and sodium nitrate is studied using a combination of rheology, small angle neutron scattering, dynamic light scattering, and cryo-transmission electron microscopy. The mixtures are single phase up to particle volume fractions of 1%. The addition of like-charged particles significantly increases the wormlike micelle (WLM) solution's zero shear rate viscosity, longest relaxation time, and storage modulus. The changes are hypothesized to originate from a close association of the particles with the micellar mesh. Small angle neutron scattering measurements with contrast matching demonstrate associations between particles mitigated by the WLMs. The effective interparticle interactions measured by SANS can explain the observed phase behavior. Dynamic light scattering measurements confirm the dynamic coupling of the particles to the micellar mesh.

A unique high-pressure rheology apparatus is used to study the in situ formation and flow properties of gas hydrates from a water-in-crude oil emulsion. Viscosity and pressure of the hydrate slurry are measured during hydrate formation, growth, aggregation, and dissociation. The rheology of the hydrate slurries varies with time, shear rate (1–500 s–1), water content (0–50%), and temperature (0–6 °C). Hydrate slurry viscosity increases rapidly with time when hydrates form and then decays after going through a maximum as hydrate aggregates breakup or rearrange. Yield stress increases with annealing time up to 8 h and then remains constant. Hydrate slurry viscosity decreases with an increasing shear rate (i.e., they are shear thinning). Viscosity and yield stress both increase with an increasing water content. During dissociation, the viscosity increases just before the hydrate equilibrium temperature. Finally, transient viscosity measurements at varying temperatures suggest that mechanisms, such as cohesion forces and shear forces, competitively affect hydrate slurry viscosity.

Gadolinium metal-organic framework (Gd MOF) nanoparticles are an interesting and novel class of nanomaterials that are being studied as a potential replacement for small molecule positive contrast agents in magnetic resonance imaging (MRI). Despite the tremendous interest in these nanoscale imaging constructs, there are limitations, particularly with respect to controlling the particle size, which need to be overcome before these nanoparticles can be integrated into in vivo applications. In an effort to control the size, shape, and size distribution of Gd MOF nanoparticles, hydrotropes were incorporated into the reverse microemulsion synthesis used to produce these nanoparticles. A study of how hydrotropes influenced the mechanism of formation of reverse micelles offered a great deal of information with respect to the physical properties of the Gd MOF nanoparticles formed. Specifically, this study incorporated the hydrotropes, sodium salicylate (NaSal), 5-methyl salicylic acid, and salicylic acid into the reverse microemulsion. Results demonstrated that addition of each of the hydrotropes into the synthesis of Gd MOFs provided a simple route to control the nanoparticle size as a function of hydrotrope concentration. Specifically, Gd MOF nanoparticles synthesized with NaSal showed the best reduction in size distributions in both length and width with percent relative standard deviations being nearly 50% less than nanoparticles produced via the standard route from the literature. Finally, the effect of the size of the Gd MOF nanoparticles with respect to their MRI relaxation properties was evaluated. Initial results indicated a positive correlation between the surface areas of the Gd MOF nanoparticles with the longitudinal relaxivity in MRI. In particular, Gd MOF nanoparticles with an average size of 82 nm with the addition of NaSal, yielded a longitudinal relaxivity value of 83.9 mM⁻¹ [Gd³⁺] sec⁻¹, one of the highest reported values compared to other Gd-based nanoparticles in the literature to date.

We demonstrate that the true hydroxide conductivity in an e-beam grafted poly(ethylene-co-tetrafluoroethylene) [ETFE] anion exchange membrane (AEM) is as high as 132 mS cm(-1) at 80 °C and 95% RH, comparable to a proton exchange membrane, but with very much less water present in the film. To understand this behaviour we studied ion transport of hydroxide, carbonate, bicarbonate and chloride, as well as water uptake and distribution. Water uptake of the AEM in water vapor is an order of magnitude lower than when submerged in liquid water. In addition (19)F pulse field gradient spin echo NMR indicates that there is little tortuosity in the ionic pathways through the film. A complete analysis of the IR spectrum of the AEM and the analyses of water absorption using FT-IR led to conclusion that the fluorinated backbone chains do not interact with water and that two types of water domains exist within the membrane. The reduction in conductivity was measured during exposure of the OH(-) form of the AEM to air at 95% RH and was seen to be much slower than the reaction of CO2 with OH(-) as the amount of water in the film determines its ionic conductivity and at relative wet RHs its re-organization is slow.