Suitably functionalized dipeptides have been shown to be effective hydrogelators. The design of the hydrogelators and the mechanism by which hydrogelation occurs are both currently not well understood. Here, we have utilized the hydrolysis of glucono-delta-lactone to gluconic acid as a means of adjusting the pH in a naphthalene-alanylvaline solution allowing the specific targeting of the final pH. In addition, this method allows the assembly process to be characterized. We show that assembly begins as charge is removed from the C-terminus of the dipeptide. The removal of charge allows lateral assembly of the molecules leading to pi-pi stacking (shown by CD) and beta-sheet formation (as shown by IR and X-ray fiber diffraction). This leads to the formation of fibrous structures. Electron microscopy reveals that thin fibers form initially, with low persistence length. Lateral association then occurs to give bundles of fibers with higher persistence length. This results in the initially weak hydrogel becoming stronger with time. The final mechanical properties of the hydrogels are very similar irrespective of the amount of GdL added; rather, the time taken to achieving the final gel is determined by the GdL concentration. However, differences are observed between the networks under strain, implying that the kinetics of assembly do impart different final materials' properties. Overall, this study provides detailed understanding of the assembly process that leads to hydrogelation.

SMA-Lipodisq nanoparticles, with one bacteriorhodopsin (bR) per 12 nm particle on average (protein/lipid molar ratio, 1:172), were prepared without the use of detergents. Using pulsed and continuous wave nitroxide spin label electron paramagnetic resonance, the structural and dynamic integrity of bR was retained when compared with data for bR obtained in the native membrane and in detergents and then with crystal data. This indicates the potential of Lipodisq nanoparticles as a useful membrane mimetic.

Long molecules such as fibrous proteins are particularly difficult to characterise structurally. We have recently designed a microvolume Couette flow linear dichroism (LD) cell whose sample volume is only 20-40 microL in contrast to previous cells where the volume of sample required has typically been of the order of 1000-2000 microL. This brings the sample requirements of LD to a level where it can be used for biological samples. Since LD is the difference in absorption of light polarised parallel to an orientation direction and perpendicular to that direction, it is the ideal technique for determining relative orientations of subunits of e.g. fibrous proteins, DNA-drug systems, etc. For solution phase samples, Couette flow orientation, whereby the sample is sandwiched between two cylinders, one of which rotates, has proved to be the optimal technique for LD experiments in many laboratories. Our capillary microvolume LD cell has been designed using extruded quartz rods and capillaries and focusing and collecting lenses. We have developed applications with PCR products, fibrous proteins, liposome-bound membrane proteins, as well as DNA-dye systems. Despite this range of applications, to date there is nothing reported in the literature to enable one to validate the performance of Couette flow LD cells. In this paper we establish validation criteria and show that the data from the microvolume cells are reproducible, vary by less than 1% with sample reloading, follow the Beer-Lambert law, and have signals linear in voltage over a wide voltage range. The microvolume cell data are consistent with those from the large-volume cells for DNA samples. Surprisingly, upon extending the wavelength range by adding the intercalator ethidium bromide, the spectra in the microvolume and large-volume cells differ by a wavelength dependent orientation parameter. This wavelength variation was concluded to be the result of Taylor-vortices in the large-volume cells which have inner rotating cylinders in our laboratory. Thus the microvolume LD cells can be concluded to provide better data than our large-volume LD cells, though the latter are still to be preferred for titration series as it is extremely difficult to add sample to the capillary cells without introducing artefacts.

Amyloid-like fibrils can be formed by many different proteins and peptides. The structural characteristics of these fibers are very similar to those of amyloid fibrils that are deposited in a number of protein misfolding diseases, including Alzheimer's disease and the transmissible spongiform encephalopathies. The elucidation of two crystal structures from an amyloid-like fibril-forming fragment of the yeast prion, Sup35, with sequence GNNQQNY, has contributed to knowledge regarding side-chain packing of amyloid-forming peptides. Both structures share a cross-beta steric zipper arrangement but vary in the packing of the peptide, particularly in terms of the tyrosine residue. We investigated the fibrillar and crystalline structure and assembly of the GNNQQNY peptide using x-ray fiber diffraction, electron microscopy, intrinsic and quenched tyrosine fluorescence, and linear dichroism. Electron micrographs reveal that at concentrations between 0.5 and 10 mg/mL, fibers form initially, followed by crystals. Fluorescence studies suggest that the environment of the tyrosine residue changes as crystals form. This is corroborated by linear dichroism experiments that indicate a change in the orientation of the tyrosine residue over time, which suggests that a structural rearrangement occurs as the crystals form. Experimental x-ray diffraction patterns from fibers and crystals also suggest that these species are structurally distinct. A comparison of experimental and calculated diffraction patterns contributes to an understanding of the different arrangements accessed by the peptide.

No abstract

Self-assembly in aqueous solution has been investigated for two Fmoc [Fmoc = N-(fluorenyl)-9-methoxycarbonyl] tetrapeptides comprising the RGDS cell adhesion motif from fibronectin or the scrambled sequence GRDS. The hydrophobic Fmoc unit confers amphiphilicity on the molecules, and introduces aromatic stacking interactions. Circular dichroism and FTIR spectroscopy show that the self-assembly of both peptides at low concentration is dominated by interactions among Fmoc units, although Fmoc-GRDS shows β-sheet features, at lower concentration than Fmoc-RGDS. Fibre X-ray diffraction indicates β-sheet formation by both peptides at sufficiently high concentration. Strong alignment effects are revealed by linear dichroism experiments for Fmoc-GRDS. Cryo-TEM and small-angle X-ray scattering (SAXS) reveal that both samples form fibrils with a diameter of approximately 10 nm. Both Fmoc-tetrapeptides form self-supporting hydrogels at sufficiently high concentration. Dynamic shear rheometry enabled measurements of the moduli for the Fmoc-GRDS hydrogel, however syneresis was observed for the Fmoc-RGDS hydrogel which was significantly less stable to shear. Molecular dynamics computer simulations were carried out considering parallel and antiparallel β-sheet configurations of systems containing 7 and 21 molecules of Fmoc-RGDS or Fmoc-GRDS, the results being analyzed in terms of both intermolecular structural parameters and energy contributions.Postprint (published version

The delivery of therapeutic peptides and proteins to the central nervous system is the biggest challenge when developing effective neuropharmaceuticals. The central issue is that the blood-brain barrier is impermeable to most molecules. Here we demonstrate the concept of employing an amphiphilic derivative of a peptide to deliver the peptide into the brain. The key to success is that the amphiphilic peptide should by design self-assemble into nanofibers wherein the active peptide epitope is tightly wrapped around the nanofiber core. The nanofiber form appears to protect the amphiphilic peptide from degradation while in the plasma, and the amphiphilic nature of the peptide promotes its transport across the blood-brain barrier. Therapeutic brain levels of the amphiphilic peptide are achieved with this strategy, compared with the absence of detectable peptide in the brain and the consequent lack of a therapeutic response when the underivatized peptide is administered.

Knowing the structure of a molecule is one of the keys to deducing its function in a biological system. However, many biomacromolecules are not amenable to structural characterisation by the powerful techniques often used namely NMR and X-ray diffraction because they are too large, or too flexible or simply refuse to crystallize. Long molecules such as DNA and fibrous proteins are two such classes of molecule. In this article the extent to which flow linear dichroism (LD) can be used to characterise the structure and function of such molecules is reviewed. Consideration is given to the issues of fluid dynamics and light scattering by such large molecules. A range of applications of LD are reviewed including (i) fibrous proteins with particular attention being given to actin; (ii) a far from comprehensive discussion of the use of LD for DNA and DNA-ligand systems; (iii) LD for the kinetics of restriction digestion of circular supercoiled DNA; and (iv) carbon nanotubes to illustrate that LD can be used on any long molecules with accessible absorption transitions.