Conventionally processed precipitation hardening aluminum alloys are generally treated with T6 heat treatments which are time-consuming and generally optimized for conventionally processed microstructures. Alternatively, parts produced by laser powder bed fusion (L-PBF) are characterized by unique microstructures made of very fine and metastable phases. These peculiar features require specifically optimized heat treatments. This work evaluates the effects of a short T6 heat treatment on L-PBF AlSi7Mg samples. The samples underwent a solution step of 15 min at 540 °C followed by water quenching and subsequently by an artificial aging at 170 °C for 2–8 h. The heat treated samples were characterized from a microstructural and mechanical point of view and compared with both as-built and direct aging (DA) treated samples. The results show that a 15 min solution treatment at 540 °C allows the dissolution of the very fine phases obtained during the L-PBF process; the subsequent heat treatment at 170 °C for 6 h makes it possible to obtain slightly lower tensile properties compared to those of the standard T6. With respect to the DA samples, higher elongation was achieved. These results show that this heat treatment can be of great benefit for the industry.
Despite the increasing interest in laser powder bed fusion (LPBF), only a few cast aluminum alloys are available for this process. This study focuses on improving the LPBF processability of the A6061 alloy, which is challenging due to its wide solidification range, the dendritic columnar grain growth, and consequent solidification cracking. To address these issues, in situ-synthesized grain refiners can be used to induce equiaxial grain growth and prevent crack formation. A6061 RAM2 powder—a mixture of A6061, Ti, and B4C—was characterized and processed using a low-power LPBF machine to create an in situ particle-reinforced metal matrix composite. Parameter optimization was performed to evaluate the effect of their variation on the printability of the alloy. Microstructural characterization of the samples revealed that the complete reaction and the synthesis of the ceramic reinforcement did not occur. However, TiAl3 was synthesized during the process and promoted a partial grain refinement, leading to the formation of equiaxial grains and preventing the formation of solidification cracks. The tensile tests carried out on the optimized samples exhibit superior mechanical properties compared to those of A6061 processed through LPBF.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.