The use of self-adhesive resin cements is an option for bonding fiber-reinforced composite posts to root canal dentin. Traditional resin cements apparently provide higher bond strengths than self-etch resin cements. Because of this, the bond strength of self-adhesive resin cements to root dentin should be evaluated. SUMMARYObjectives: This study evaluated the bond strength of luting systems for bonding glass fiber posts to root canal dentin. The hypothesis tested was that there are no differences in bond strength of glass fiber posts luted with different cement systems.Methods: Forty bovine incisors were randomly assigned to five different resin cement groups (n=8). After endodontic treatment and crown removal, translucent glass fiber posts were bonded into the root canal using five different luting protocols (self-cured cement and etchand-rinse adhesive system; dual-cured cement and etch-and-rinse adhesive system; self-cured cement and self-etch adhesive system; dualcured cement and self-etch adhesive system; and dual-cured self-adhesive cement). Pushout bond strength was evaluated at three different radicular levels: cervical, middle,

Hydrogen peroxide at a lower concentration (e.g., 15%) should be considered a good treatment alternative for in-office bleaching because the higher concentration for in-office bleaching generates a greater risk and intensity of TS for patients.

Dermoid cysts in oral cavity are unusual lesions. Their etiology is not yet clear and can be associated with trapped cells as a result of the inclusion error resulting in the development into the ectoderm, mesoderm, and endoderm tissues. The aim of this case report is to evidence the presence of a dermoid cyst in the floor of mouth surgically removed. In the present case, the lesion showed soft consistency, floating, regular borders, smooth surface, and the same color as the adjacent mucosa, asymptomatic and measuring 4.5 × 5.5 cm in its greatest diameter. The initial diagnostic was ranula in consequence of the similarity with clinical characteristics and localization. After surgical removal lesion, a fibrotic capsule was identified with a friable material with intensive yellow color. The microscopic exam showed cystic lesion with cavity lined by squamous stratified epithelium hyperorthokeratinized. Cutaneous attachments, such as sebaceous glands and hair follicles, were present in connective adjacent tissue. Surgical intervention is elective in these situations. All dentists must have a thorough knowledge of this unusual lesion.

The solubility, pH, electrical conductivity, and radiopacity of AH Plus and MTA FillApex were evaluated. In addition, the surfaces morphologies of the sealers were analyzed by using scanning electron microscopy. For pH test, the samples were immersed in distilled water at different periods of time. The same solution was used for electrical conductivity measurement. The solubility and radiopacity were evaluated according to ANSI/ADA. Statistical analyses were carried out at 5% level of significance. MTA FillApex presented higher mean value for solubility and electrical conductivity. No significant difference was observed in the mean values for pH reading. AH Plus presented higher radiopacity mean values. MTA FillApex presented an external surface with porosities and a wide range of sizes. In conclusion, the materials fulfill the ANSI/ADA requirements when considering the radiopacity and solubility. AH Plus revealed a compact and homogeneous surface with more regular aspects and equal particle sizes.

BackgroundConsidering the current high consumption of energy drinks, the aim of the present study is to evaluate the influence of energy drinks in removing the smear layer and exposing dentinal tubules on root surface.MethodsDentine root surfaces were exposed using a diamond bur. Forty movements of scaling were performed in the area prepared in order to create a smear layer. One hundred and thirty specimens were obtained from 35 teeth. Specimens were randomly distributed into 12 groups (n = 10) and divided into subgroups according to the application: topical (n = 5) and friction (n = 5). Twelve energy drinks were evaluated: RedBull™, Burn™, TNT™, Flash Power™, Flying Horse™, Sports Drink™, Ionic™, Hot Power™, Army Power™, Gladiator™ and Bug™. Distilled water was used as a control group. The specimens were analysed by scanning electron microscopy.ResultsTopical application: a significant influence of energy drinks on smear layer removal was found for FlyingHorse™ and Bug™ when compared with the control group. Friction application: significant smear layer removal was found for Burn™, FlyingHorse™, Gladiator™, SportsDrinks™, when compared with the control group. Comparing the different application forms, a statistically significant difference was found for Army Power™.ConclusionConsidering the significant smear layer removal, energy drinks can be an important etiological factor for cervical dentine hypersensitivity.

SUMMARY Purpose The objective of this study was to evaluate if the application method (tip with brush or tip without brush) and hydrogen peroxide (HP) concentration (6% or 35% self-mixing) of in-office bleaching gel influences the penetration of HP into the pulp chamber, color change, and the amount of bleaching gel used. Methods Forty healthy premolars were randomly divided into the following five groups (n=8): no treatment; HP6% using a tip with a brush, HP6% using a tip without a brush, HP35% using a tip with a brush, and HP35% using a tip without a brush. After treatments, the HP concentration (μg/mL) within the pulp chamber was determined using UV-Vis spectrophotometry. The color change (ΔEab, ΔE00, and ΔWID) was evaluated using a digital spectrophotometer. The amount of gel used (g) in each group was measured using a precision analytical balance. Data from each test were submitted to parametric tests (α=0.05). Results The tip with a brush resulted in a lower amount of HP inside the pulp chamber and less gel used when compared with the tip without a brush, regardless of HP concentration (p<0.05). However, regarding the tip used, although no significant difference was observed when HP35% was used (p>0.05), a higher whitening effect was observed when the 6% HP was applied without a brush as opposed to with a tip brush (p<0.05). Conclusions The use of a tip with a brush, regardless of the in-office bleaching gel concentration (6% or 35% self-mixing), presented a lower penetration and lower volume of spent gel when compared to a tip without brush. However, the whitening effect depends on the concentration of HP used.

No abstract

Hydrogen peroxide (H 2 O 2 )-based products are effective in tooth whitening; however, their safety is controversial as they may harm patient tissues/cells. These effects are suggested to be concentration-dependent; nonetheless, to date, there are no reports on H 2 O 2 -mediated oxidative damage in the gingival tissue, and neither whether this can be detected in gingival crevicular fluid (GCF) samples. We hypothesize that H 2 O 2 whitening products may cause collateral oxidative tissue damage following in office application. Therefore, H 2 O 2 and nitric oxide (NO) levels were investigated in GCF samples obtained from patients undergoing dental bleaching with H 2 O 2 at different concentrations, in a randomized, double-blind, split-mouth clinical trial. A proteomic analysis of these samples was also performed. H 2 O 2 -based whitening products promoted inflammation which was detected in GCF samples and lasted for longer following 35% H 2 O 2 bleaching. This included time-dependent changes in NO levels and in the abundance of proteins associated with NO synthesis, oxidative stress, neutrophil regulation, nucleic acid damage, cell survival and/or tissue regeneration. Overall, H 2 O 2 -based products used in office promote inflammation irrespective of their concentration. As the inflammation caused by 35% H 2 O 2 is longer , patients may benefit better from using lower concentrations of this bleaching product, as they may result in less tissue damage.