The total phosphorus (TP) concentration, as the primary limiting eutrophication factor in the Mahabad Dam reservoir in Iran, was studied, considering the combined impacts of climate change, as well as the scenarios on changes in upstream TP loadings and downstream dam water allocations. Downscaled daily projected climate data were obtained from the Beijing Normal University Earth System Model (BNU-ESM) under moderate (RCP4.5) and extreme (RCP8.5) scenarios. These data were used as inputs of a calibrated Soil and Water Assessment Tool (SWAT) model of the watershed in order to determine the effects of climate change on runoff yields in the watershed from 2020 to 2050. The SWAT model was calibrated/validated using the SUFI-2 algorithm in the SWAT Calibration Uncertainties Program (SWAT-CUP). Moreover, to model TP concentration in the reservoir and to investigate the effects of upstream/downstream scenarios, along with forecasted climate-induced changes in streamflow and evaporation rates, the System Dynamics (SD) model was implemented. The scenarios covered a combination of changes in population, agricultural and livestock farming activities, industrialization, water conservation, and pollution control. Relative to the year 2011 in which the water quality data were available, the SD results showed the highest TP concentrations in the reservoir under scenarios in which the inflow to the reservoir had decreased, while the upstream TP loadings and downstream dam water allocations had increased (+29.9%). On the other hand, the lowest TP concentration was observed under scenarios in which upstream TP loadings and dam water allocations had decreased (−18.5%).
The reliability of a wastewater treatment plant is a critical issue when the effluent is reused or discharged to water resources. Main factors affecting the performance of the wastewater treatment plant are the variation of the influent, inherent variability in the treatment processes, deficiencies in design, mechanical equipment, and operational failures. Thus, meeting the established reuse/discharge criteria requires assessment of plant reliability. Among many techniques developed in system reliability analysis, fault tree analysis (FTA) is one of the popular and efficient methods. FTA is a top down, deductive failure analysis in which an undesired state of a system is analyzed. In this study, the problem of reliability was studied on Tehran West Town wastewater treatment plant. This plant is a conventional activated sludge process, and the effluent is reused in landscape irrigation. The fault tree diagram was established with the violation of allowable effluent BOD as the top event in the diagram, and the deficiencies of the system were identified based on the developed model. Some basic events are operator's mistake, physical damage, and design problems. The analytical method is minimal cut sets (based on numerical probability) and Monte Carlo simulation. Basic event probabilities were calculated according to available data and experts' opinions. The results showed that human factors, especially human error had a great effect on top event occurrence. The mechanical, climate, and sewer system factors were in subsequent tier. Literature shows applying FTA has been seldom used in the past wastewater treatment plant (WWTP) risk analysis studies. Thus, the developed FTA model in this study considerably improves the insight into causal failure analysis of a WWTP. It provides an efficient tool for WWTP operators and decision makers to achieve the standard limits in wastewater reuse and discharge to the environment.
This study investigates the impact of different digital elevation model (DEM) resolutions on the topological attributes and simulated runoff, as well as the sensitivity of runoff parameters in the Mahabad Dam watershed in Iran. The watershed and streamlines were delineated in ArcGIS, and the hydrologic analyses were performed using the Soil and Water Assessment Tool (SWAT). The sensitivity analysis on runoff parameters was performed, using the Sequential Uncertainties FItting Ver. 2 algorithm, in the SWAT Calibration and Uncertainty Procedures (SWAT-CUP) program. The results indicated that the sensitivity of runoff parameters, watershed surface area, and elevations changed under different DEM resolutions. As the distribution of slopes changed using different DEMs, surface parameters were most affected. Furthermore, higher amounts of runoff were generated when DEMs with finer resolutions were implemented. In comparison with the observed value of 8 m3/s at the watershed outlet, the 12.5 m DEM showed more realistic results (6.77 m3/s). Comparatively, the 12.5 m DEM generated 0.74% and 2.73% more runoff compared with the 30 and 90 m DEMs, respectively. The findings of this study indicate that in order to reduce computation time, researchers may use DEMs with coarser resolutions at the expense of minor decreases in accuracy.
Mountainous regions in Iran are important sources of surface water supply and groundwater recharge. Therefore, accurate simulation of hydrologic processes in mountains at large scales is important for water resource management and for watershed management planning. Snow hydrology is the more important hydrologic process in mountainous watersheds. Therefore, streamflow simulation in mountainous watersheds is often challenging because of irregular topography and complex hydrological processes. In this study, the Soil and Water Assessment Tool (SWAT) was used to model daily runoff in the Taleghan mountainous watershed (800.5 km 2 ) in west of Tehran, Iran. Most of the precipitation in the study area takes place as snow, therefore, modeling daily streamflow in this river is very complex and with large uncertainty. Model calibration was performed with Particle Swarm Optimization. The main input data for simulation of SWAT including Digital Elevation Model (DEM), land use, soil type and soil properties, and hydro-climatological data, were appropriately collected. Model performance was evaluated both visually and statistically where a good relation between observed and simulated discharge was found. The results showed that the coefficient of determination R 2 and the NashSutcliffe coefficient NS values were 0.80 and 0.78, respectively. The calibrated model was most sensitive to snowmelt parameters and CN 2 (Curve Number). Results indicated that SWAT can provide reasonable predictions daily streamflow from Taleghan watersheds.
Using the Storm Water Management Model (SWMM), this study evaluated the impacts of (a) 20% and 50% urbanization at the mountainous Mahabad Dam watershed in Iran, as probable future land developments, (b) the urbanization location (near the outlet, in the middle, and at the far end of the watershed), (c) climate variability (increase in evaporation and rainfall intensity), and (d) implementing vegetative swales as low impact developments (LIDs), on watershed-generated runoff and pollutant loads (total suspended solids (TSS), total nitrogen (TN), and total phosphorus (TP)). Combination of the above-mentioned factors resulted in 17 scenarios, and each scenario was run for a 12-hour simulation in the model. The results indicated that based on land developments, areas with more dominant agricultural land generated more TN and TP, areas with more undeveloped lands generated more TSS, and more urbanized areas generated more runoff. Moreover, the 50% urbanization scenario resulted in more runoff and pollutant loads, compared with the 20% urbanization scenario. Under scenarios with climate variability, runoff and pollutant load peaks occurred earlier in time, due to the higher intensity rainfall events. Furthermore, LIDs decreased pollutant loads up to 25%, indicating their effectiveness in decreasing the impact of urbanization on receiving water bodies.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.