No abstract

Longwave Infrared Camera (LIR) on board Akatsuki first revealed the global structure of the thermal tides in the upper cloud layer of Venus. The data were acquired over three Venusian years, and the analysis was done over the areas from the equator to the midlatitudes in both hemispheres and over the whole local time. Thermal tides at two vertical levels were analyzed by comparing data at two different emission angles. Dynamical wave modes consisting of tides were identified; the diurnal tide consisted mainly of Rossby‐wave and gravity‐wave modes, while the semidiurnal tide predominantly consisted of a gravity‐wave mode. The revealed vertical structures were roughly consistent with the above wave modes, but some discrepancy remained if the waves were supposed to be monochromatic. In turn, the heating profile that excites the tidal waves can be constrained to match this discrepancy, which would greatly advance the understanding of the Venusian atmosphere.

The existence of large stationary gravity waves was discovered during Akatsuki's first observation sequence in 2015. In this study, the further detection of large stationary gravity waves in brightness temperature images over a 1.5 year period is reported. The waves periodically appeared mostly above four specific highland regions in the low latitudes when these regions were in the local afternoon. The wave amplitudes attenuated after the wave locations passed beyond the evening terminator, and the locations of the waves tended to slowly drift eastward over their lifetimes. The appearances of stationary waves depend not only on surface topography but also on latitude and local time, suggesting that solar heating during the daytime and atmospheric structure affected by solar heating may control the excitation and propagation of stationary waves. Plain Language Summary The Japanese Venus satellite "Akatsuki" has repeatedly found large atmospheric waves with north-south lengths, which sometimes reach more than 10,000 km at the cloud top level on Venus (altitude~70 km). These waves have repeatedly appeared above the Venusian highlands in low latitudes, such as Aphrodite Terra. Interestingly, the waves appeared and became clearer each time the highlands passed from noon to evening; therefore, they can be regarded as "daily" Venusian phenomena. Despite westward wind speeds reaching 100 m s À1 at the cloud top level (known as atmospheric superrotation), the east-west propagation speeds of the large waves were nearly zero, and the waves stayed above their initial locations (stationary). This means that the origin of the waves could be the highland terrains below. Because waves can transport energy via propagation, stationary waves may transport atmospheric energy from the lower atmosphere to the cloud top level and may affect the speed of the superrotation. The existence and regular appearance of the large stationary waves indicate a continuous interaction between the lower and upper atmospheres on Venus via wave propagation, which provides a novel perspective of the Venusian atmosphere.

The Longwave Infrared Camera (LIR) is one of a suite of cameras onboard the Venus orbiter Akatsuki. It will take images of thermal radiation in the wavelength range of 8-12 µm emitted by the Venus cloud tops. The use of an uncooled micro-bolometer array as an infrared image sensor makes LIR a lightweight, small and lowpower consumption instrument with a required noise equivalent temperature difference of 0.3 K. Temperature and horizontal wind fields at the cloud-top will be retrieved for both dayside and nightside with equal quality. This will provide key observations to understand the mechanism of super rotation and the thermal budget of the planet. LIR will also monitor variations of the polar dipole and collar which are characteristic thermal features in the Venusian atmosphere. Mechanisms of the upper-cloud formation will be investigated using sequences of close-up images. The morphology of the nightside upper cloud will be studied in detail for the first time.

We provide an overview of data products from observations by the Japanese Venus Climate Orbiter, Akatsuki, and describe the definition and content of each data-processing level. Levels 1 and 2 consist of non-calibrated and calibrated radiance (or brightness temperature), respectively, as well as geometry information (e.g., illumination angles). Level 3 data are global-grid data in the regular longitude-latitude coordinate system, produced from the contents of Level 2. Non-negligible errors in navigational data and instrumental alignment can result in serious errors in the geometry calculations. Such errors cause mismapping of the data and lead to inconsistencies between radiances and illumination angles, along with errors in cloud-motion vectors. Thus, we carefully correct the boresight pointing of each camera by fitting an ellipse to the observed Venusian limb to provide improved longitude-latitude maps for Level 3 products, if possible. The accuracy of the pointing correction is also estimated statistically by simulating observed limb distributions. The results show that our algorithm successfully corrects instrumental pointing and will enable a variety of studies on the Venusian atmosphere using Akatsuki data.