We explore the application of a high-temperature precursor delivery system for depositing high boiling point organosilicate precursors on plastics using atmospheric plasma. Dense silica coatings were deposited on stretched poly(methyl methacrylate), polycarbonate and silicon substrates from the high boiling temperature precursor, 1, 2-bis(triethoxysilyl)ethane, and from two widely used low boiling temperature precursors, tetraethoxysilane and tetramethylcyclotetrasiloxane. The coating deposition rate, molecular network structure, density, Young's modulus and adhesion to plastics exhibited a strong dependence on the precursor delivery temperature and rate, and the functionality and number of silicon atoms in the precursor molecules. The Young's modulus of the coatings ranged from 6 to 34 GPa, depending strongly on the coating density. The adhesion of the coatings to plastics was affected by both the chemical structure of the precursor and the extent of exposure of the plastic substrate to the plasma during the initial stage of deposition. The optimum combinations of Young's modulus and adhesion were achieved with the high boiling point precursor which produced coatings with high Young's modulus and good adhesion compared to commercial polysiloxane hard coatings on plastics.

Oxygen atmospheric plasma was used to pretreat polycarbonate (PC) and stretched poly(methyl methacrylate) (PMMA) surfaces in order to enhance the adhesion of the dense silica coatings deposited by atmospheric plasma on the polymer substrates. The treatment time and chemical structure of the polymers were found to be important factors. For PC, a short treatment increased the adhesion energy, while longer treatment times decreased the adhesion. In contrast, plasma pretreatment monotonically decreased the adhesion of PMMA, and pristine PMMA exhibited much higher adhesion than the PC counterpart. We found that adhesion enhancement was achieved through improved chemical bonding, chain interdiffusion, and mechanical interlocking at the coating/substrate interface, after a short atmospheric plasma treatment. Decreased adhesion resulted from overoxidation and low-molecular-weight weak layer formation on the polymer surface by prolonged atmospheric plasma treatment. The dramatic differences in the behavior of PC and PMMA in relation to the plasma treatment time were due to their dissimilar resistance to atmospheric plasma exposure.

No abstract

Methods utilizing stem cells hold tremendous promise for tissue engineering applications; however, many issues must be worked out before these therapies can be routinely applied. Utilization of external cues for preimplantation expansion and differentiation offers a potentially viable approach to the use of stem cells in tissue engineering. The studies reported here focus on the response of murine neural stem cells encapsulated in alginate hydrogel beads to alternating current electric fields. Cell viability and differentiation was studied as a function of electric field magnitude and frequency. We applied fields of frequency (0.1-10) Hz, and found a marked peak in neural stem cell viability under oscillatory electric fields with a frequency of 1 Hz. We also found an enhanced propensity for astrocyte differentiation over neuronal differentiation in the 1 Hz cultures, as compared to the other field frequencies we studied.

No abstract

No abstract

No abstract

Prof. Pozzo's research interests are in the area of soft materials and nanotechnology. His group focuses on developing structure-function relationships for a variety of nano-structured materials having applications in materials, alternative energy and separations. Prof. Pozzo obtained his B.S. from the University of Puerto Rico at Mayagez and his PhD in Chemical Engineering from Carnegie Mellon University in Pittsburgh PA. He also worked in the NIST Center for Neutron Research and is currently an Assistant Professor of Chemical Engineering at the University of Washington where he has served since 2007.