The phase transformation to ausferrite during austempered ductile iron (ADI) heat treatment can be significantly influenced by the alloying element Mo. Utilizing neutron diffraction, the phase transformation from austenite to ausferrite was monitored in-situ during the heat treatment. In addition to the phase volume fractions, the carbon enrichment of retained austenite was investigated. The results from neutron diffraction were compared to the macroscopic length change from dilatometer measurements. They show that the dilatometer data are only of limited use for the investigation of ausferrite formation. However, they allow deriving the time of maximum carbon accumulation in the retained austenite. In addition, the transformation of austenite during ausferritization was investigated using metallographic methods. Finally, the distribution of the alloying elements in the vicinity of the austenite/ferrite interface zone was shown by atom probe tomography (APT) measurements. C and Mn were enriched within the interface, while Si concentration was reduced. The Mo concentration in ferrite, interface and austentite stayed at the same level. The delay of austenite decay during Stage II reaction caused by Mo was studied in detail at 400 °C for the initial material as well as for 0.25 mass % and 0.50 mass % Mo additions.

In-situ synchrotron diffraction and atom probe tomography (APT) have been used to study the carbon diffusion and redistribution process in austempered ductile iron (ADI) during austempering. The process of carbon content change in bainitic ferrite during different austempering temperatures has been determined quantitatively. The transformation in ADI is controlled by decarburization of supersaturated ferrite and carbide precipitation and has been found to be divided into three stages based on a model developed for bainitic steels by Takahashi and Bhadeshia. The formation, morphology and composition of carbides and carbon clusters in ferrite after austempering have been identified unequivocally by APT. Finally, the relationships of carbon content in ferrite, carbon gap values, and austempering temperatures in the ADI alloy were expressed using empirical equations.

The strain induced martensitic transformation in austempered ductile iron (ADI) has been investigated using high resolution neutron diffraction on samples compressed ex-situ to different plastic strains. In addition bulk texture measurements using neutron diffraction have been performed to calculate the orientation distribution of ferrite and austenite phases for different strain levels. Combing the detailed texture information with neutron diffraction pattern proved to be essential for quantitative phase analysis and extraction of martensite phase fractions. The martensite content induced by strain in ADI depends on austempering temperature and degree of deformation.

A modified quenching and deformation dilatometer is now in operation at the Heinz Maier‐Leibnitz Zentrum neutron center. It is customized for running neutron scattering measurements during the temperature/deformation treatment of the sample, in particular neutron diffraction (phase, texture, lattice strain) and neutron small angle scattering. Further details can be found in the article number http://doi.wiley.com/10.1002/adem.202100163 by Xiaohu Li, Weimin Gan, and co‐workers.