The formation of typical low‐temperature oxidation products is observed in laminar premixed low‐pressure flames investigated by photoionization molecular‐beam mass spectrometry at the Swiss Light Source. The C1–C4 alkyl hydroperoxides can be identified in n‐butane‐ and 2‐butene‐doped hydrogen flames by their photoionization efficiency spectra at m/z 48, 62, 76, and 90. C1–C3 alkyl hydroperoxides are also observed in a propane‐doped hydrogen flame and in a neat propane flame. In addition, threshold photoelectron spectra reveal the presence of the alkyl hydroperoxides. In the 2‐butene/H2 flame, the photoionization spectrum at m/z 88 also enables the identification of butenyl hydroperoxides by comparison with calculated ionization energies of the alkenyl hydroperoxides and a literature spectrum. The low‐temperature species are formed close to the burner surface with maximum mole fractions at 0.25–0.75 mm above the burner. At 0.5 mm, even the methylperoxy radical (CH3OO) is measured for the first time in a laminar premixed flame. The rate of production analyses show that consumption of the hydroperoxyalkyl radicals results in the formation of cyclic ethers. In the n‐butane/H2 flame, ethylene oxide, oxetane, and methyloxirane are identified. Besides expected small oxygenated species, for example, formaldehyde or acetaldehyde, the larger C4 oxygenates butanone (C2H5COCH3) and 2,3‐butanedione (C4H6O2) are formed in the two C4 hydrocarbon‐doped hydrogen flames. Quantification of alkyl hydroperoxides with estimated photoionization cross sections based on the corresponding alcohols, which have similar photoelectron structures to the alkyl hydroperoxides, shows that mole fractions are on the order of 10−5–10−6 in the n‐butane/H2 flame. Measurements are corroborated by simulations, which also predict the presence of some peroxides in detectable concentrations, that is, mole fractions larger than 10−7, under the investigated conditions. The observation of peroxide species and cyclic ethers in the investigated laminar premixed flames give new insights into the contribution of low‐temperature combustion chemistry in a flame.

A pressurized flow reactor combustion experiment interfaced with synchrotron double imaging photoelectron photoion coincidence spectroscopy, Rev. Sci. Instrum. 91 (2020) 045115.

No nitryl hydride was detected in partial oxidation of nitric oxide doped methane, despite recent theoretical reaction rates suggesting otherwise.

Pinenes and pinene dimers have similar energy densities to petroleum-based fuels and are regarded as alternative fuels. The pyrolysis of the pinenes is well studied, but information on their combustion kinetics is limited. Three stoichiometric, flat premixed flames of the C 10 H 16 monoterpenes α-pinene, β-pinene, and myrcene were investigated by synchrotron-based photoionization molecular-beam mass spectrometry (PI-MBMS) at the Advanced Light Source (ALS). This technique allows isomerresolved identification and quantification of the flame species formed during the combustion process.Flame-sampling molecular-beam mass spectrometry even enables the detection of very reactive radical species. Myrcene was chosen because of its known formation during β-pinene pyrolysis. The quantitative speciation data and the discussed decomposition steps of the fuels provide important information for the development of future chemical kinetic reaction mechanisms concerning pinene combustion. The main decomposition of myrcene starts with the unimolecular cleavage of the carbon-carbon single bond between the two allylic carbon atoms. Further decompositions by βscission to stable combustion intermediates such as isoprene (C 5 H 8 ), 1,2,3-butatriene (C 4 H 4 ) or allene (aC 3 H 4 ) are consistent with the observed species pool. Concentrations of all detected hydrocarbons in the β-pinene flame are closer to the myrcene flame than to the α-pinene flame.These similarities and the direct identification of myrcene by its photoionization efficiency spectrum during β-pinene combustion indicate that β-pinene undergoes isomerization to myrcene under the studied flame conditions. Aromatic species such as phenylacetylene (C 8 H 6 ), styrene (C 8 H 8 ), xylenes (C 8 H 10 ), and indene (C 9 H 8 ) could be clearly identified and have higher concentrations in the αpinene flame. Conclusively, a higher sooting tendency can generally be expected for this monoterpene. The presented quantitative speciation data of flat premixed flames of the three monoterpenes α-pinene, β-pinene, and myrcene give insights into their combustion kinetics.

No abstract