The surface quality of injection molded parts depends on the processing conditions, the cavity surface structure, the runner system, the used polymer and the part geometry. Different replication of the cavity surface structure to the molded part influences its surface function and visual appearance. A descriptive model of the replication process has been developed, taking into account the thickness of the frozen layer during injection. The expected dependencies were proven by systematic injection molding tests with geometric surface micro structures, having depths of 45 or 100 μm and widths from 400 to 2000 μm, that were replicated into high-crystalline polypropylene (HCPP) and polycarbonate (PC). The volumetric structure replication ratio increased with rising mold temperature, melt temperature and cavity pressure. As expected, the mold temperature was dominant for very small micro features. The RMS roughness, determined by confocal microscopy and atomic-force microscopy, was found to be a suitable replication parameter for draw-polished to mirror-finished stochastic cavity surface structures. An abrupt change in wall thickness decelerated the flow front velocity, thus decreased the replicated polymer surface roughness and increased the surface gloss. Moreover, a several micrometer high “surface step” remained, due to the different thickness-dependent shrinkage. This step always ascended from the thicker to the thinner part area. The replication of a mirror-finished mold surface into HCPP was dominated by morphological effects. Local micro shrinkage differences led to micro sink marks, which affected the surface gloss much more than the mold surface structure.

Injection molding is the most important process to produce plastic parts. Because of increasing complexity of the plastic parts and the aim to reach zero-defect production it is a must to control the dynamic injection molding process. Therefore information from the inside of the mold, measured with sensors, is necessary. State of the art is to implement wired mold cavity pressure sensors as well as wired cavity temperature sensors. This article presents a novel wireless measurement setup which uses structure borne sound as transport medium. The sound is generated by an acoustic actor which is activated by the passing flow front at certain predetermined positions in the cavity (or cavities). Beside the mechanical setup of the sensor proof of concept measurements with a prototype setup are shown in this article.

No abstract

No abstract

-Surfaces of technical parts are getting more and more attention in terms of functionalization. By modification, additional functionality is given to the part, e.g. self-cleaning effect or antireflection behavior. Nowadays mainly flat surfaces are structured which is a consequence of the available production methods. However, the demand of micro structured free form surfaces is increasing, enabling novel products. A major problem in the mass production (e.g. injection molding) of structured freeform surfaces is to demold these structures without ripping or deforming them due to occurring undercuts. Recently a novel concept was developed which overcomes this limitation. A nickel substrate containing a structure composed of lines orientated in two different directions, one orientated in melt flow direction, the other one perpendicular to that, but both with a cross-section of approximately 45 μm x 55 μm (w x h) was used as a premaster to cast a flexible master. This master made of poly(dimethylsiloxane) (PDMS) was mounted on a bending edge in an injection mold cavity. Within this paper the influence of process parameters on the replication grade of the structure lines depending on the structure orientation was evaluated, varying the holding pressure, melt and mold temperature using statistical design of experiment methods. The replication grade was evaluated by characterizing the shape of the structure lines along the entire process chain, using an infinite focus system. The results show, that the melt temperature has the biggest influence on the dimensions of the structures, the mold temperature only a slight one.