Four new dimeric bis(BF(2))-2,2'-bidipyrrins (bisBODIPYs), and their corresponding BODIPY monomers, have been prepared and studied with respect to their structural and photophysical properties. The solid-state molecular structure of the dimers and the relative orientation of the subunits have been revealed by an X-ray diffraction study, which showed that the molecules contain two directly linked BODIPY chromophores in a conformationally fixed, almost orthogonal arrangement. Two of the fluorine atoms are in close contact with each other and the (19)F NMR spectra show a characteristic through-space coupling in solution. The new chromophores all exhibit a clear exciton splitting in the absorption spectra with maxima at about 490 and 560 nm, and are highly luminescent with an intense emission band at around 640 nm. The Stokes shift, which is the difference between the maximum of the lowest-energy absorption band and the maximum of the emission band, has a typical value of 5 to 15 nm for simple BODIPYs, whereas this value increases to 80 nm or more for the dimers, along with a slight decrease in fluorescence quantum yields and lifetimes. These properties indicate potential uses of these new fluorophoric materials as functional dyes in biomedical and materials applications and also in model compounds for BODIPY aggregates.

Synthesis of the C(8) BODIPY monomers, dimers, and trimers, a C(8) polymer, and N(8) aza-BODIPY monomer and dimer was carried out. Methyl and mesityl C(8)-substituted monomers, dimers, and trimers were used. Dimers, trimers, and polymer were formed chemically through the β-β (2/6) positions by oxidative coupling using FeCl(3). A red shift of the absorbance and fluorescence is observed with addition of monomer units from monomer to polymer for C(8) dyes. The aza-BODIPY dye shows red-shifted absorbance and fluorescence compared with the C(8) analogue. Cyclic voltammetry shows one, two, and three one-electron waves on both reduction and oxidation for the monomer, dimer, and trimer, respectively, for the C(8) BODIPYs. The separation for the reduction peaks for the C(8) dimers is 0.12 V compared with 0.22 V for the oxidation, while the trimers show separations of 0.09 V between reduction peaks and 0.13 V for oxidation peaks. The larger separations between the second and third peaks, 0.25 V for the oxidation and 0.2 V for the reduction, are consistent with a larger energy to remove or add a third electron compared with the second one. The BODIPY polymer shows the presence of many sequential one-electron waves with a small separation. These results provide evidence for significant electronic interactions between different monomer units. The aza-BODIPY dye shows a reduction peak 0.8 V more positive compared to the C(8) compound. Aza-BODIPY dimer shows the appearance of four waves in dichloromethane. The separation between two consecutive waves is around 0.12 V for reduction compared with 0.2 V for oxidation, which is comparable with the results for the C(8) dyes. Electrogenerated chemiluminescence (ECL) of the different species was obtained, including weak ECL of the polymer.

A molecular model system of tetraphenyl porphyrins (TPP) adsorbed on metallic substrates is systematically investigated within a joint scanning tunnelling microscopy/molecular modelling approach. The molecular conformation of TPP molecules, their adsorption on a gold surface and the growth of highly ordered TPP islands are modelled with a combination of density functional theory and dynamic force field methods. The results indicate a subtle interplay between different contributions. The molecule-substrate interaction causes a bending of the porphyrin core which also determines the relative orientations of phenyl legs attached to the core. A major consequence of this is a characteristic (and energetically most favourable) arrangement of molecules within self-assembled molecular clusters; the phenyl legs of adjacent molecules are not aligned parallel to each other (often denoted as pi-pi stacking) but perpendicularly in a T-shaped arrangement. The results of the simulations are fully consistent with the scanning tunnelling microscopy observations, in terms of the symmetries of individual molecules, orientation and relative alignment of molecules in the self-assembled clusters.

No abstract

No abstract

The photophysical and spectroscopic characterization of four new dimeric bis(BF 2 )-2,2 0 -bidipyrrins (BisBODIPYs) recently synthesized and characterized (Chem. Eur. J., 2008, 14, 2976-2983 has been undertaken along with that of the component BODIPY monomers. The monomers display the typical photophysical properties of this family; (i) narrow and intense single absorption band in the visible range at 530 nm; (ii) intense, solvent independent emission (F fl ca. 1); (iii) narrow emission band with a 200-400 cm À1 Stokes shifted emission, independent of solvent polarity; (iv) no absorption features for the singlet excited state; (v) very little triplet yield and no ability to sensitize singlet oxygen. The absorption spectra of the corresponding new dimers exhibit split band maxima in the visible range at about 490 and 560 nm, corresponding to an exciton splitting of ca. 2600 cm À1 . The luminescence in toluene is strong (F fl ca. 0.7, t =3.4 ns), broad and Stokes shifted by ca. 2200 cm À1 , but both luminescence yield and Stokes shift are solvent polarity dependent; F fl o 0.1, t o 1 ns and the Stokes shift is close to 2700 cm À1 in acetonitrile. Solvent viscosity does not appear to play an important role and freezing of the solvents to 77 K in a solid matrix cancels the differences in luminescence parameters. Singlet and triplet excited state absorbance was measured in toluene and acetonitrile and the ability of these new dyes to sensitize singlet oxygen was examined. The nature and dynamics of the excited state is discussed in comparison with the monomers properties and with some intra-or inter-molecular BODIPY dimers reported in the literature. Potential applications of these new dyes with respect to BODIPYs are pointed out on the basis of their spectroscopic and photophysical properties. Results and discussion Absorption in tolueneThe absorption spectra of some representative cases of the dimers studied in toluene solutions are reported in Fig. 1 with

The electrochemistry of several difluoroboradiaza-s-indacene (BODIPY) compounds lacking substituent groups in the meso (8)- and/or 3 (α)-positions was investigated. Chemical and electrochemical dimerization was demonstrated, and the dimerization depended on the character of substitution. The chemical dimerization was achieved by oxidative coupling using FeCl(3) in CH(2)Cl(2) at 0 °C. The electrochemical dimerization proceeded via anodic oxidation to the radical cation and monitored by both cyclic voltammetry (CV) and electrogenerated chemiluminescence (ECL). An available open 3-position was important for the formation of the dimer. The resulting 3,3'-dimer produced a second peak in the CV oxidation and also the appearance of a longer wavelength ECL peak at 656 nm, which is considerably shifted from the parent peak at 532 nm. No dimerization was seen for BODIPY molecules in which only the meso 8-position was unsubstituted, either by chemical or electrochemical means, demonstrating that dimerization occurs at position 3.

The exciton chirality method (ECM) is commonly recognized as one of the best approaches to assign the absolute configuration of biaryls. This paper reports the first exception to this method for a simple biaryl system. ECD and VCD measurements in combination with DFT (B3LYP/6-311G*), TDDFT (CAM-B3LYP/6-311G*), and Coupled-Cluster (RI-SCS-CC2) calculations were used to determine the absolute configurations of axially chiral BODIPY DYEmers. The ECM fails to predict the sign of the intense CD couplet at 500 nm of the 1,1'-coupled dimer. The odd behavior was rationalized by considering the strong transition magnetic dipole associated with the 500 nm transition, which leads to an unexpected dominance of the μm coupling at the expense of the μμ one in these compounds. This is the first case in which a strong μm coupling hampers the use of the ECM, but this behavior should not be restricted to the BODIPY chromophore.