Firefly luciferase catalyzes the highly efficient emission of yellow-green light from substrate luciferin by a sequence of reactions that require Mg-ATP and molecular oxygen. We previously reported [Branchini, B. R., Magyar, R. A., Marcantonio, K. M., Newberry, K. J., Stroh, J. G., Hinz, L. K., and Murtiashaw, M. H. (1997) J. Biol. Chem. 272, 19359-19364] that 2-(4-benzoylphenyl)thiazole-4-carboxylic acid (BPTC), a firefly luciferin analogue, was a potent photoinactivation reagent for luciferase. We identified a luciferase peptide 244HHGF247, the degradation of which was directly correlated to the photooxidation process. We report here the construction and purification of wild-type and mutant luciferases H244F, H245F, H245A, and H245D. The results of photoinactivation and kinetic and bioluminescence studies with these proteins are consistent with His245 being the primary functional target of BPTC-catalyzed enzyme inactivation. The possibility that His245 is oxidized to aspartate during the photooxidation reaction was supported by the extremely low specific activity ( approximately 300-fold lower than WT) of the H245D mutant. Using the crystal structures of luciferase without substrates [Conti, E., Franks, N. P., and Brick, P. (1996) Structure 4, 287-298] and the functionally related phenylalanine-activating subunit of gramicidin synthetase 1 [Conti, E., Stachelhaus, T., Marahiel, M. A., and Brick, P. (1997) EMBO J. 16, 4174-4183] as a starting point, we have performed molecular-modeling studies and propose here a model for the luciferase active site with substrates luciferin and Mg-ATP bound. We have used this model to provide a structure-based interpretation of the role of 244HHGF247 in firefly bioluminescence.

Beetle luciferases (including those of the firefly) use the same luciferin substrate to naturally display light ranging in color from green (lambda(max) approximately 530 nm) to red (lambda(max) approximately 635 nm). In a recent communication, we reported (Branchini, B. R., Murtiashaw, M. H., Magyar, R. A., Portier, N. C., Ruggiero, M. C., and Stroh, J. G. (2002) J. Am. Chem. Soc. 124, 2112-2113) that the synthetic adenylate of firefly luciferin analogue D-5,5-dimethylluciferin was transformed into the emitter 5,5-dimethyloxyluciferin in bioluminescence reactions catalyzed by luciferases from Photinus pyralis and the click beetle Pyrophorus plagiophthalamus. 5,5-Dimethyloxyluciferin is constrained to exist in the keto form and fluoresces mainly in the red. However, bioluminescence spectra revealed that green light emission was produced by the firefly enzyme, and red light was observed with the click beetle protein. These results, augmented with steady-state kinetic studies, were taken as experimental support for mechanisms of firefly bioluminescence color that require only a single keto form of oxyluciferin. We report here the results of mutagenesis studies designed to determine the basis of the observed differences in bioluminescence color with the analogue adenylate. Mutants of P. pyralis luciferase putative active site residues Gly246 and Phe250, as well as corresponding click beetle residues Ala243 and Ser247 were constructed and characterized using bioluminescence emission spectroscopy and steady state kinetics with adenylate substrates. Based on an analysis of these and recently reported (Branchini, B. R., Southworth, T. L., Murtiashaw, M. H., Boije, H., and Fleet, S. E. (2003) Biochemistry 42, 10429-10436) data, we have developed an alternative mechanism of bioluminescence color. The basis of the mechanism is that luciferase modulates emission color by controlling the resonance-based charge delocalization of the anionic keto form of the oxyluciferin excited state.

Beetle luciferases (including those of the firefly) use the same luciferin substrate to naturally display light ranging in color from green (lambda(max) similar 530 nm) to red (lambda(max) similar 635 nm). The original mechanism of bioluminescence color determination advanced by White and co-workers was based on the concept that the keto and enol tautomers of the emitter oxyluciferin produce red and green light, respectively. Alternatively, McCapra proposed that color variation is associated with conformations of the keto form of excited-state oxyluciferin. We have prepared the adenylate of D-5,5-dimethylluciferin and shown that it is transformed into the putative emitter 5,5-dimethyloxyluciferin in bioluminescence reactions catalyzed by luciferases from Photinus pyralis and the green-emitting click beetle. 5,5-Dimethyloxyluciferin is constrained to exist in the keto form and fluoresces in the red. However, bioluminescence spectra revealed that green light emission was produced by the firefly enzyme and red light was observed with the click beetle protein. These results, augmented with steady-state kinetic studies, may be taken as the first experimental support for McCapra's mechanism of firefly bioluminescence color or any other proposal that requires only a single keto form of oxyluciferin.

No abstract

Under physiological conditions firefly luciferase catalyzes the highly efficient emission of yellow-green light from the substrates luciferin, Mg-ATP, and oxygen. In nature, bioluminescence emission by beetle luciferases is observed in colors ranging from green (approximately 530 nm) to red (approximately 635 nm), yet all known luciferases use the same luciferin substrate. In an earlier report [Branchini, B. R., Magyar, R. M., Murtiashaw, M. H., Anderson, S. M., and Zimmer, M. (1998) Biochemistry 37, 15311-15319], we described the effects of mutations at His245 on luciferase activity. In the context of molecular modeling results, we proposed that His245 is located at the luciferase active site. We noted too that the H245 mutants displayed red-shifted bioluminescent emission spectra. We report here the construction and purification of additional His245 mutants, as well as mutants at residues Lys529 and Thr343, all of which are stringently conserved in the beetle luciferase sequences. Analysis of specific activity and steady-state kinetic constants suggested that these residues are involved in luciferase catalysis and the productive binding of substrates. Bioluminescence emission spectroscopy studies indicated that point mutations at His245 and Thr343 produced luciferases that emitted light over the color range from green to red. The results of mutational and biochemical studies with luciferase reported here have enabled us to propose speculative mechanisms for color determination in firefly bioluminescence. An essential role for Thr343, the participation of His245 and Arg218, and the involvement of bound AMP are indicated.

Firefly luciferase catalyzes the highly efficient emission of yellow-green light from substrate firefly luciferin by a sequence of reactions that require Mg-ATP and molecular oxygen. We had previously developed a working model of the luciferase active site based on the X-ray structure of the enzyme without bound substrates. In our model, the side chain guanidinium group of Arg218 appears to be located in close proximity to the substrate's hydroxyl group at the bottom of the luciferin binding pocket. A similar role for Arg337 also has been proposed. We report here the construction, purification, and characterization of mutant luciferases R218A, R218Q, R218K, R337Q, and R337K. Alteration of the Arg218 side chain produced enzymes with 15-20-fold increases in the Km values for luciferin. The contrasting near-normal Km values for luciferin determined with the Arg337 enzymes support our proposal that Arg218 (and not Arg337) is an essential luciferin binding site residue. Bioluminescence emission studies indicated that in the absence of a positively charged group at position 218, red bioluminescence was produced. Based on this result and those of additional fluorescence experiments, we speculate that Arg218 maintains the polarity and rigidity of the emitter binding site necessary for the normal yellow-green emission of P. pyralis luciferase. The findings reported here are interpreted in the context of the firefly luciferase X-ray structures and computational-based models of the active site.

Firefly luciferase catalyzes the highly efficient emission of yellow-green light from substrate firefly luciferin by a sequence of reactions that require Mg-ATP and molecular oxygen. We had previously developed [Branchini, B. R., Magyar, R. A., Murtiashaw, M. H., Anderson, S. M., and Zimmer, M. (1998) Biochemistry 37, 15311-15319] a molecular graphics-based working model of the luciferase active site starting with the first X-ray structure [Conti, E., Franks, N. P., and Brick, P. (1996) Structure 4, 287-298] of the enzyme without bound substrates. In our model, the luciferin binding site contains 15 residues that are within 5 A of the substrate. Using site-directed mutagenesis, we made changes at all of these residues and report here the characterization of the corresponding expressed and purified proteins. Of the 15 residues studied, 12 had a significantly (>or=4-fold K(m) difference) altered binding affinity for luciferin and seven residues, spanning the primary sequence region Arg218-Ala348, had substantially (>or=30 nm) red-shifted bioluminescence emission maxima when mutated. We report here an interpretation of the roles of the mutated residues in substrate binding and bioluminescence color determination. The results of this study generally substantiate the accuracy of our model and provide the foundation for future experiments designed to alter the substrate specificity of firefly luciferase.

Firefly luciferase catalyzes the highly efficient emission of yellow-green light from the substrates luciferin, Mg-ATP, and oxygen in a two-step process. The enzyme first catalyzes the adenylation of the carboxylate substrate luciferin with Mg-ATP followed by the oxidation of the acyl-adenylate to the light-emitting oxyluciferin product. The beetle luciferases are members of a large family of nonbioluminescent proteins that catalyze reactions of ATP with carboxylate substrates to form acyl-adenylates. Formation of the luciferase-luciferyl-AMP complex is a specific example of the chemistry common to this enzyme family. Site-directed mutants at positions Lys529, Thr343, and His245 were studied to determine the effects of the amino acid changes at these positions on the individual luciferase-catalyzed adenylation and oxidation reactions. The results suggest that Lys529 is a critical residue for effective substrate orientation and that it provides favorable polar interactions important for transition state stabilization leading to efficient adenylate production. These findings as well as those with the Thr343 and His245 mutants are interpreted in the context of the firefly luciferase X-ray structures and computational-based models of the active site.