Southern pine boards, both untreated and treated with a fire retardant, were exposed to either a room temperature or high temperature (66°C (150°F)) environment. Strength properties were measured after 1 and 1-1/2 years of exposure, respectively. The degree of polymerization and the chemical composition of αcellulose isolated from the exposed wood were measured. Little relationship was found between degree of polymerization and strength. However, a strong relationship was found between the amount of mannan in the α-cellulose isolated from the wood and the modulus of rupture and the work-tomaximum load of solid wood. This correlation leads to the conclusion that hemicellulose plays an important role in determining the strength of wood.

No abstract

A primary failure mode for environmental barrier coatings (EBCs) on SiC ceramic matrix composites (CMCs) is the oxidation of the intermediate Si‐bond coating, where the formation of SiO2 at the bond coating–EBC interface results in debonding and spallation. This work compares the microstructure evolution and steam oxidation kinetics of the Si‐bond coating beneath yttrium/ytterbium disilicate ((Y/Yb)DS) and ytterbium disilicate/monosilicate (YbDS/YbMS) EBCs to better understand the impact of EBC composition on oxidation kinetics. After 500 1‐h cycles at 1350°C, (Y/Yb)DS displayed a decreasing concentration of the monosilicate minor phase and increasing concentration of porosity as furnace cycling time increased, whereas the YbDS/YbMS EBC displayed negligible microstructural evolution. For both EBC systems, thermally grown oxide growth rates in steam were found to increase by approximately an order magnitude compared to dry air oxidation. The (Y/Yb)DS EBC displayed a reduced steam oxidation rate compared to YbDS/YbMS.