The reversible photoswitching between the 'on' and 'off' states of the fluorescent protein Dronpa involves photoisomerization as well as protein side-chain rearrangements, but the process of interconversion remains poorly characterized. Here we use time-resolved infrared measurements to monitor the sequence of these structural changes, but also of proton transfer events, which are crucial to the development of spectroscopic contrast. Light-induced deprotonation of the chromophore phenolic oxygen in the off state is a thermal ground-state process, which follows ultrafast (9 ps) trans-cis photoisomerization, and so does not involve excited-state proton transfer. Steady-state infrared difference measurements exclude protonation of the imidazolinone nitrogen in both the on and off states. Pump-probe infrared measurements of the on state reveal a weakening of the hydrogen bonding between Arg66 and the chromophore C ¼ O, which could be central to initiating structural rearrangement of Arg66 and His193 coinciding with the low quantum yield cis-trans photoisomerization

Femtosecond time resolved pump-probe protein X-ray crystallography requires highly accurate measurements of the photoinduced structure factor amplitude differences. In the case of femtosecond photolysis of single P63 crystals of the Photoactive Yellow Protein, it is shown that photochemical dynamics place a considerable restraint on the achievable time resolution due to the requirement to stretch and add second order dispersion in order to generate threshold concentration levels in the interaction region. Here, we report on using a 'quasi-cw' approach to use the rotation method with monochromatic radiation and 2 eV bandwidth at 9.465 keV at the Linac Coherent Light Source operated in SASE mode. A source of significant Bragg reflection intensity noise is identified from the combination of mode structure and jitter with very small mosaic spread of the crystals and very low convergence of the XFEL source. The accuracy with which the three dimensional reflection is approximated by the 'quasi-cw' rotation method with the pulsed source is modelled from the experimentally collected X-ray pulse intensities together with the measured rocking curves. This model is extended to predict merging statistics for recently demonstrated self seeded mode generated pulse train with improved stability, in addition to extrapolating to single crystal experiments with increased mosaic spread. The results show that the noise level can be adequately modelled in this manner, indicating that the large intensity fluctuations dominate the merged signal-to-noise (I/σI) value. Furthermore, these results predict that using the self seeded mode together with more mosaic crystals, sufficient accuracy may be obtained in order to resolve typical photoinduced structure factor amplitude differences, as taken from representative synchrotron results.

This paper describes the investigation of an optical parametric oscillator (OPO) set-up based on two beta barium borate (BBO) crystals, where the interplay between the crystal orientations, cut angles and air dispersion substantially influenced the OPO performance, and especially the angular spectrum of the output beam. Theory suggests that if two BBO crystals are used in this type of design, they should be of different cuts. This paper aims to provide an experimental manifestation of this fact. Furthermore, it has been shown that air dispersion produces similar effects and should be taken into account. An x-ray crystallographic indexing of the crystals was performed as an independent test of the above conclusions.