No abstract

No abstract

In situ plasma functionalization during manufacturing of CNT/polymer composites.

Carbon nanotubes (CNTs) are considered the most promising candidates to replace Cu and Al in a large number of electrical, mechanical and thermal applications. Although most CNT industrial applications require macro and micro size CNT fiber assemblies, several techniques to make conducting CNT fibers, threads, yarns and ropes have been reported to this day, and improvement of their electrical and mechanical conductivity continues. Some electrical applications of these CNT conducting fibers require an insulating layer for electrical insulation and protection against mechanical tearing. Ideally, a flexible insulator such as hydrogenated nitrile butadiene rubber (HNBR) on the CNT fiber can allow fabrication of CNT coils that can be assembled into lightweight, corrosion resistant electrical motors and transformers. HNBR is a largely used commercial polymer that unlike other cable-coating polymers such as polyvinyl chloride (PVC), it provides unique continuous and uniform coating on the CNT fibers. The polymer coated/insulated CNT fibers have a 26.54 μm average diameter—which is approximately four times the diameter of a red blood cell—is produced by a simple dip-coating process. Our results confirm that HNBR in solution creates a few microns uniform insulation and mechanical protection over a CNT fiber that is used as the electrically conducting core.

No abstract

This work describes the design and fabrication of free-standing carbon nanotube-palladium (CNT-Pd) composite sheets for hydrogen gas sensing. The CNT-Pd composites were made by electroplating palladium onto a solvent-densified and oxygen plasma-treated CNT sheet. The latter was prepared using high purity CNTs drawn from a dense, vertically aligned array grown by chemical vapor deposition on silicon substrates. The CNT-Pd sheets were characterized by energy-dispersive spectroscopy, scanning electron microscopy, and X-ray diffraction. The amount of palladium in the composite was 16.5 wt % as measured via thermogravimetric analysis. Thin strips of the CNT-Pd sheets were assembled as chemiresistor sensors and tested for hydrogen gas detection. The sensors demonstrated a limit of detection of 0.1 mol % and displayed signal reversibility without the need for oxygen removal or heat treatment. A decrease in signal reversibility was observed after multiple exposure cycles; however, redensification with ethanol significantly restored the original reversibility. The sensor showed the Freundlich adsorption isotherm behavior when exposed to hydrogen. The material's potential application toward a wearable, flexible sensor was demonstrated by integrating the chemiresistor onto a fabric material using hot-press processing and testing the composite for hydrogen sensitivity.

Individual Carbon Nanotubes (CNTs) have a great mechanical strength that needs to be transferred into macroscopic fiber assemblies. One approach to improve the mechanical strength of the CNT assemblies is by creating covalent bonding among their individual CNT building blocks. Chemical cross-linking of multiwall CNTs (MWCNTs) within the fiber has significantly improved the strength of MWCNT thread. Results reported in this work show that the cross-linked thread had a tensile strength six times greater than the strength of its control counterpart, a pristine MWCNT thread (1192 MPa and 194 MPa, respectively). Additionally, electrical conductivity changes were observed, revealing 2123.40 S·cm−1 for cross-linked thread, and 3984.26 S·cm−1 for pristine CNT thread. Characterization suggests that the obtained high tensile strength is due to the cross-linking reaction of amine groups from ethylenediamine plasma-functionalized CNT with the epoxy groups of the cross-linking agent, 4,4-methylenebis(N,N-diglycidylaniline).

No abstract