The high-resolution separation of double-stranded DNA (dsDNA) has important applications in physical mapping strategies and in the analysis of polymerase chain reaction (PCR) products. Although high-resolution separations of dsDNA by capillary electrophoresis (CE) have been reported, pulsed fields were required to achieve complete resolution of DNA fragments beyond 23 kilobase pairs (kbp). Here, we report a single formulation to separate a broad range (80 bp-40 kbp) of DNA fragments without the use of pulsed fields. We used a low-viscosity sieving medium (ca. 5 cP, at 25 degrees C) based on polyethyleneoxide (PEO) to separate DNA fragments up to 40 kbp. The matrix contained a mixture of 0.5% PEO (Mn 10(6)) to separate fragments up to 1.5 kbp, combined with 0.1% PEO (Mn 8 x 10(6)) to separate fragments between 1-40 kbp, within a single run. All PEO matrix formulations tested were compatible with a variety of intercalating dyes and with two different capillary wall coating methods. We obtained a detection limit of 25 fg of a 200 bp DNA quantitation standard using Vistra Green in the matrix. Resolution was best using short injection times (5 s or less) and low field strengths (approximately 100 V/cm). Sample runs were complete in 70 min, and use of the capillary array electrophoresis (CAE) system permitted high-throughput DNA analysis. The size range separated is approximately 10 times greater than with conventional slab gel separations.

The Human Genome Initiative has increased significantly the rate at which disease-causing genes are being mapped and sequenced. New cost-effective methods to locate the genes and to characterize disease-causing mutations require robust, reproducible, and accurate protocols for measuring DNA fragment lengths. Capillary array electrophoresis (CAE) offers rapid, high-resolution separations, high throughput, and sensitive detection. To assess the utility of CAE for the accumulation of genetic information, we tested both sizing accuracy and reproducibility using 48-capillary prototype systems. Two multiplex PCR allelic ladder standards and several CA-repeat markers were analyzed in >100 runs. Reproducibility in typing >8000 genotypes reveals a standard deviation of less than 0.2 bp on these systems under optimized conditions. However, sequence-dependent migration anomalies were observed at most simple sequence loci even when analyzed under denaturing conditions, resulting in a systematic bias in estimated fragment sizes. We show here that, by normalizing results to known typing controls, one can obtain locus-averaged accuracies of <0.06 bp and normalized results within I bp of actual. We detect as little as a 1:30,000 dilution of a DNA quantitation standard stained with highly sensitive intercalating dyes, indicating an 80-zeptomole sensitivity limit. However, to obtain reproducible electrokinetic injection, -200 attomoles of fluorescein-labeled DNA is required. These sensitivity limits, sizing precision, and accuracy, together with the I-hr run times for 48-96 samples, indicate that CAE is a viable method for high-throughput genetic analysis of simple sequence repeat polymorphisms.

The profiling of polymorphic short tandem repeat (STR) markers is being applied to human identification, parentage testing and genetic mapping. Reliable genotyping of these markers is facilitated by polymerase chain reaction (PCR) amplification and high-resolution electrophoretic separation. Capillary array electrophoresis (CAE) offers very rapid, high-resolution separation of the amplified DNA and potential for automated sample processing not realized employing conventional slab-gel electrophoresis. The use of CAE to type DNA samples amplified at 11 genetic loci in multiplex profiles is presented. Two sets totaling 208 samples were amplified in a multiplex fashion using AmpFlSTR-Blue or AmpFlSTR-Green I and analyzed in a blind study using CAE. With the exception of one sample, the CAE genotyping results were in complete agreement with results obtained using a single-capillary system or two slab-gel electrophoresis systems. The sample, genotype TH01 7/10, migrated similar to TH01 6.3/9.3 allele sizes, which suggested a potential band migration shift. The recommended approach to such an observation is to analyze the sample again. The sample was rerun and correct genotype verified. Allelic ladder samples were analyzed multiple times by CAE to determine sizing accuracy and precision. The sizing of over 240 allelic ladder samples yielded an average within-run precision of +/- 0.13 bp and between-run precision of +/- 0.21 bp for fragments up to 350 bp. The CAE protocols permit processing of up to 96 multiplex STR samples in under 70 min.

No abstract

No abstract