Fabrication of silver nanoparticle colloids using ultrashort pulse laser ablation in water is studied. Ablation in liquid flow improves the reproducibility and increases the nanoparticle productivity by 380% compared to stationary liquid. Femtosecond laser ablation in water is 20% more efficient than picosecond laser ablation, but due to higher picosecond laser power (higher repetition rate), the nanoparticle productivity at the same pulse fluence is three times higher for picosecond laser ablation. With picosecond laser pulses, the maximum productivity of 8.6μg∕s is achieved at a pulse energy of 110μJ and repetition rate of 50kHz.

An overview on femtosecond laser pulse shaping techniques applied to control of the initial photo-physical steps involved in materials processing is presented. First, pulse shaping methodology in frequency domain is introduced and examples of shaped pulses relevant to laser microfabrication are discussed. Then, the use of tailored femtosecond pulses to control the initial steps of laser processing of high band gap materials is demonstrated. In particular, control on basic ionization processes acting as the initial photo-physical step of the ablation dynamics is exerted by highly asymmetric femtosecond laser pulse shapes generated by Third Order Dispersion (TOD).

No abstract

Ultra-short laser pulses are frequently used for material removal (ablation) in science, technology and medicine. However, the laser energy is often used inefficiently, thus, leading to low ablation rates. For the efficient ablation of a rectangular shaped cavity, the numerous process parameters such as scanning speed, distance between scanned lines, and spot size on the sample, have to be optimized. Therefore, finding the optimal set of process parameters is always a time-demanding and challenging task. Clear theoretical understanding of the influence of the process parameters on the material removal rate can improve the efficiency of laser energy utilization and enhance the ablation rate. In this work, a new model of rectangular cavity ablation is introduced. The model takes into account the decrease in ablation threshold, as well as saturation of the ablation depth with increasing number of pulses per spot. Scanning electron microscopy and the stylus profilometry were employed to characterize the ablated depth and evaluate the material removal rate. The numerical modelling showed a good agreement with the experimental results. High speed mimicking of bio-inspired functional surfaces by laser irradiation has been demonstrated.

No abstract