Copolymers of ethylene and butadiene were prepared using the ansa-bisfluorenyl Me2Si(C13H8)2NdR complex in combination with dialkylmagnesium as a chain transfer agent. Thorough kinetic studies and computational mechanistic investigations of this copolymerization reaction were performed. Combined with detailed analyses of the polymer microstructure and chainends, these studies demonstrate that the entitled copolymerization operates according to a living coordinative chain transfer copolymerization of ethylene and butadiene. Besides, in addition to the formation of the previously described 1,2-cyclohexane inner chain cyclic motif, the presence of bicyclic 1,5-decalin units via the formation of transient vinylcyclohexyl-methyl chain-end is discussed in the present communication. The non-accumulation of the vinylcyclohexane motif within the chains is explained by the reversibility of its formation, as interpreted with the help of DFT calculations, or by its rapid conversion into decalin motif after one ethylene insertion. Finally, this study also illustrates the ability of the fluorenyl ligand to adjust its binding mode on demand in order to avoid inhibition of catalyst.

A range of dialkenylmagnesium compounds ([CH2CH­(CH2) n ]2Mg; n = 1–6) were synthesized and used as chain transfer agents (CTA) with either (C5Me5)2NdCl2Li­(OEt2)2 (1) or [Me2Si­(C13H8)2Nd­(BH4)2Li­(thf)]2 (2) neodymium precursors for the polymerization of ethylene. In all cases, the systems followed a controlled coordinative chain transfer polymerization mechanism. The intramolecular insertion of the vinyl group on the CTA in growing chains is possible and led to the formation of cyclopentyl, cyclohexyl, and possibly cycloheptyl chain ends. While the production of cyclopentyl- or cyclohexyl-capped polyethylene chains can be quantitative (n = 2–5), the integrity of this double bond can also be kept if n is higher than 6. In comparison to 1/CTA catalytic systems, 2/CTA catalytic systems showed a higher propensity to produce cycloalkyl chain ends. This was ascribed to the lower steric demand around the active site, as shown by DFT calculations. In addition, the formation of bis­(cyclopentylmethyl)­magnesium from dipentenylmagnesium using a catalytic amount of 2 was shown.