Arabinoxylan (AX) samples of decreasing ferulic acid (FA) contents were chemically prepared from water-extractable wheat arabinoxylans without affecting their other structural properties. Gels were obtained from these partially feruloylated WEAX (PF-WEAX) by enzymatic covalent cross-linking of FA leading to the formation of diferulic (di-FA) and tri-ferulic acid (tri-FA). WEAX gelling ability was found related to the WEAX FA content whereas the gel structure and properties depended on the density of newly formed covalent cross-links. FA content of WEAX ranging from 1.4 to 2.3 microg/mg AX gave gels with di-FA cross-links contents from 0.20 to 0.43 microg/mg AX and G' values from 5 to 44 Pa. For WEAX gels with initial FA contents from 1.6 to 2.3 microg/mg AX, average mesh size ranging from 331 to 263 nm were calculated from swelling experiments. Cross-linking densities of gels, determined from swelling experiments, were higher than those that could be theoretically estimated from the di-FA and tri-FA content of WEAX gels. This result suggests that, in addition to di-FA and tri-FA, higher ferulate cross-linking and physical entanglements would contribute to the final WEAX gel structure.

No abstract

Chemical (vapors of formaldehyde), physical (temperature, UV and gamma radiation), and aging treatments were applied to wheat gluten films. Changes in film mechanical properties, water vapor permeability, solubility, and color coordinates were investigated. An aging of 360 h led to a 75 and 314% increase in tensile strength and Young's modulus, respectively, and a 36% decrease in elongation. Severe thermal (above 110 degrees C, 15 min) and formaldehyde treatments highly improved the mechanical resistance of the films. Under these conditions, up to 376 and 654% increase in tensile strength and Young's modulus and up to 66% decrease in elongation have been observed. Water solubility was only slightly modified, whereas water vapor permeability was not affected. Color coordinates of films heated above 95 degrees C changed to a great extent. An almost total insolubilization of proteins in sodium dodecyl sulfate occurred for heat- and formaldehyde-treated films, due to the modification of protein network leading to changes in properties of the films.