Background Self-efficacy has been shown to be positively related to undergraduate engi-

When using qualitative coding techniques, establishing inter-rater reliability (IRR) is a recognized method of ensuring the trustworthiness of the study when multiple researchers are involved with coding.

In this article, we report on the fabrication of 0.3-lm average grain-sized transparent yttria ceramics using a modified twostep sintering approach. This process yielded full densification of the yttria ceramics with a drastically reduced grain growth. These transparent yttria ceramics exhibited a transparency equivalent to that of single crystals in the near-infrared spectral region. The microhardness and fracture toughness of the 0.3-lm average grain-sized transparent yttria ceramics fabricated by a modified two-step sintering were found to exceed those of B300lm average grain-sized transparent yttria ceramics fabricated by conventional sintering by 25 and 70%, respectively.

No abstract

The mechanical properties of dentin and enamel affect the reliability and wear properties of a tooth. This study investigated the influence of clinical dental treatments and procedures, such as whitening treatments or etching prior to restorative procedures. Both autoclaved and non-autoclaved teeth were studied in order to allow for both comparison with published values and improved clinical relevance. Nanoindentation analysis with the Oliver-Pharr model provided elastic modulus and hardness across the dentin-enamel junction (DEJ). Large increases were observed in the elastic modulus of enamel in teeth that had been autoclaved (52.0GPa versus 113.4GPa), while smaller increases were observed in the dentin (17.9GPa versus 27.9GPa). Likewise, there was an increase in the hardness of enamel (2.0GPa versus 4.3GPa) and dentin (0.5GPa versus 0.7GPa) with autoclaving. These changes suggested that the range of elastic modulus and hardness values previously reported in literature may be partially due to the sterilization procedures. Treatment of the exterior of non-autoclaved teeth with Crest Whitestrips™, Opalescence™ or UltraEtch™ caused changes in the mechanical properties of both the enamel and dentin. Those treated with Crest Whitestrips™ showed a reduction in the elastic modulus of enamel (55.3GPa to 32.7GPa) and increase in the elastic modulus of dentin (17.2GPa to 24.3GPa). Opalescence™ treatments did not significantly affect the enamel properties, but did result in a decrease in modulus of dentin (18.5GPa to 15.1GPa). Additionally, as expected, UltraEtch™ treatment decreased the modulus and hardness of enamel (48.7GPa to 38.0GPa and 1.9GPa to 1.5GPa, respectively) and dentin (21.4GPa to 15.0GPa and 1.9GPa to 1.5GPa, respectively). Changes in the mechanical properties were linked to altered protein concentration within the tooth, as evidenced by fluorescence microscopy and Fourier transform infrared spectroscopy.