The sensitivity, or insensitivity, of catalysed reactions to catalyst structure is a commonly employed fundamental concept. Here we report on the nature of nano-catalysed ethylene hydrogenation, investigated through experiments on size-selected Ptn (n=8–15) clusters soft-landed on magnesia and first-principles simulations, yielding benchmark information about the validity of structure sensitivity/insensitivity at the bottom of the catalyst size range. Both ethylene-hydrogenation-to-ethane and the parallel hydrogenation–dehydrogenation ethylidyne-producing route are considered, uncovering that at the <1 nm size-scale the reaction exhibits characteristics consistent with structure sensitivity, in contrast to structure insensitivity found for larger particles. The onset of catalysed hydrogenation occurs for Ptn (n≥10) clusters at T>150 K, with maximum room temperature reactivity observed for Pt13. Structure insensitivity, inherent for specific cluster sizes, is induced in the more active Pt13 by a temperature increase up to 400 K leading to ethylidyne formation. Control of sub-nanometre particle size may be used for tuning catalysed hydrogenation activity and selectivity.

Employing rationally designed model systems with precise atom-by-atom particle size control, we demonstrate by means of combining noninvasive in situ indirect nanoplasmonic sensing and ex situ scanning transmission electron microscopy that monomodal size-selected platinum cluster catalysts on different supports exhibit remarkable intrinsic sintering resistance even under reaction conditions. The observed stability is related to suppression of Ostwald ripening by elimination of its main driving force via size-selection. This study thus constitutes a general blueprint for the rational design of sintering resistant catalyst systems and for efficient experimental strategies to determine sintering mechanisms. Moreover, this is the first systematic experimental investigation of sintering processes in nanoparticle systems with an initially perfectly monomodal size distribution under ambient conditions.

Ethylene hydrogenation was investigated on size-selected Pt13 clusters supported on three amorphous silica (a-SiO2 ) thin films with different stoichiometries. Activity measurements of the reaction at 300 K revealed that on a silicon-rich and a stoichiometric film, Pt13 exhibits a similar activity to that of Pt(111), in line with the known structure insensitivity of the reaction. On an oxygen-rich film, a threefold increased rate was measured. Pulsing ethylene at 400 K, then measuring the activity at 300 K, resulted in complete loss of activity on the silicon-rich surface compared to only marginal losses on the other surfaces. The measured reactivity trends correlate with charging characteristics of a Pt13 cluster on the SiO2 films, predicted through first-principle calculations. The results reveal that the stoichiometry-dependent charging by the support can be used to tune the selectivity of reaction pathways during a catalytic hydrogenation reaction.

The nature of the nano-catalyzed hydrogenation of ethylene, yielding benchmark information pertaining to the concept of structure sensitivity/insensitivity and its applicability at the bottom of the catalyst particle size-range, is explored with experiments on size-selected Ptn (n=7-40) clusters softlanded on MgO, in conjunction with first-principles simulations. As in the case of larger particles both the direct ethylene hydrogenation channel and the parallel hydrogenation-dehydrogenation ethylidyne-producing route must be considered, with the fundamental uncovering that at the <1 nm size-scale the reaction exhibits characteristics consistent with structure sensitivity, in contrast to the structure insensitivity found for larger particles. In this size-regime, the chemical properties can be modulated and tuned by a single atom, reflected by the onset of low temperature hydrogenation at T >150 K catalyzed by Pt n (n≥10) clusters, with maximum room temperature reactivity observed for Pt 13 using a pulsed molecular beam technique. Structure insensitive behavior, inherent for specific cluster sizes at ambient temperatures, can be induced in the more active sizes, e.g. Pt 13 , by a temperature increase, up to 400 K, which opens dehydrogenation channels leading to ethylidyne formation. This reaction channel was, however found to be attenuated on Pt 20 , as catalyst activity remained elevated after the 400 K step. Pt 30 displayed behavior which can be understood from extrapolating bulk properties to this size range; in particular the calculated d-band center. In the non-scalable subnanometer size regime, however, precise control of particle size may be used for atom-by-atom tuning and manipulation of catalyzed hydrogenation activity and selectivity.

Ethylene hydrogenation catalyzed at 300 K by 1-1.5 nm nanoparticles of Ni, Pd and Pt supported on MgO(100) with a narrow size-distribution, as well as the deactivation under reaction conditions at 400 K, were investigated with pulsed molecular beam experiments. Ni nanoparticles deactivate readily at 300 K, whereas Pd particles deactivate only after pulsing at 400 K, and Pt particles were found to retain hydrogenation activity even after the 400 K heating step. The hydrogenation turnover frequency normalized to the number of particles exhibited the trend, Pt>Pd>Ni. The activity/deactivation was found to scale with the location of the particles' d-band centroid, ε c , with respect to the Fermi energy of the respective metals calculated with density-functional theory. An ε c closer to the Fermi level is indicative of a facile deactivation/low activity and an ε c farther from the Fermi level is characteristic of higher activity/impeded deactivation. CO adsorption, probed with infrared reflection absorption spectroscopy was used to investigate the clusters before and after the reaction, and the spectral features correlated with the observed catalytic behavior.