As regulatory measures for improved fuel economy and decreased emissions are pushing gasoline engine combustion technologies towards extreme conditions (i.e., boosted and intercooled intake with exhaust gas recirculation), fuel ignition characteristics become increasingly important for enabling stable operation. This study explores the effects of chemical composition on the fundamental ignition behavior of gasoline fuels. Two well-characterized, high-octane, non-oxygenated FACE (Fuels for Advanced Combustion Engines) gasolines, FACE F and FACE G, having similar antiknock indices but different octane sensitivities and chemical compositions are studied. Ignition experiments were conducted in shock tubes and a rapid compression machine (RCM) at nominal pressures of 20 and 40 atm, equivalence ratios of 0.5 and 1.0, and temperatures ranging from 650 to 1270 K. Results at temperatures above 900 K indicate that ignition delay time is similar for these fuels. However, RCM measurements below 900 K demonstrate a stronger negative temperature coefficient behavior for the FACE F gasoline having lower octane sensitivity. In addition, RCM pressure profiles under two-stage ignition conditions illustrate that the magnitude of low-temperature heat release (LTHR) increases with decreasing fuel octane sensitivity. However, intermediate-temperature heat release is shown to increase as fuel octane sensitivity increases. Various surrogate fuel mixtures were formulated to conduct chemical kinetic modeling, and complex KAUST multicomponent surrogate mixtures were shown to reproduce experimentally observed trends better than simpler two-and three-component mixtures composed of n-heptane, iso-octane, and toluene. Measurements in a Cooperative Fuels Research (CFR) engine demonstrated that the KAUST multicomponent surrogates accurately captured the antiknock quality of the FACE gasolines. Simulations were performed using multicomponent surrogates for FACE F and G to reveal the underlying chemical kinetics linking fuel composition with ignition characteristics. A key discovery of this work is the kinetic coupling between aromatics and naphthenes, which affects the radical pool population and thereby controls ignition.

iso-Octane (2,2,4-trimethylpentane) is a primary reference fuel and an important component of gasoline fuels. Moreover, it is a key component used in surrogates to study the ignition and burning characteristics of gasoline fuels. This paper presents an updated chemical kinetic model for iso-octane combustion. Specifically, the thermodynamic data and reaction kinetics of isooctane have been reassessed based on new thermodynamic group values and recently evaluated

The lack of scientific evidence on the constituents, properties, and health effects of second-hand waterpipe smoke has fueled controversy over whether public smoking bans should include the waterpipe. The purpose of this study was to investigate and compare emissions of ultrafine particles (UFP, <100 nm), carcinogenic polyaromatic hydrocarbons (PAH), volatile aldehydes, and carbon monoxide (CO) for cigarettes and narghile (shisha, hookah) waterpipes. These smoke constituents are associated with a variety of cancers, and heart and pulmonary diseases, and span the volatility range found in tobacco smoke. Sidestream cigarette and waterpipe smoke was captured and aged in a 1 m3 Teflon-coated chamber operating at 1.5 air changes per hour (ACH). The chamber was characterized for particle mass and number surface deposition rates. UFP and CO concentrations were measured online using a fast particle spectrometer (TSI 3090 Engine Exhaust Particle Sizer), and an indoor air quality monitor. Particulate PAH and gaseous volatile aldehydes were captured on glass fiber filters and DNPH-coated SPE cartridges, respectively, and analyzed off-line using GC–MS and HPLC–MS. PAH compounds quantified were the 5- and 6-ring compounds of the EPA priority list. Measured aldehydes consisted of formaldehyde, acetaldehyde, acrolein, methacrolein, and propionaldehyde. We found that a single waterpipe use session emits in the sidestream smoke approximately four times the carcinogenic PAH, four times the volatile aldehydes, and 30 times the CO of a single cigarette. Accounting for exhaled mainstream smoke, and given a habitual smoker smoking rate of 2 cigarettes per hour, during a typical one-hour waterpipe use session a waterpipe smoker likely generates ambient carcinogens and toxicants equivalent to 2–10 cigarette smokers, depending on the compound in question. There is therefore good reason to include waterpipe tobacco smoking in public smoking bans.

Very little is known about the quality and quantity of toxicants yielded by the narghile, a subject of increasing importance as this method of tobacco smoking has become popular all over the world. This study is concerned with the identification and quantification of volatile aldehydes in the gas and particle phases of mainstream narghile smoke generated using a popular type of flavored ma'ssel tobacco mixture. These compounds were analyzed based on a modified version of the Environmental Protection Agency compendium method TO-11A. Using a standardized smoking machine protocol consisting of 171 puffs, 2.6 s puff duration and 17 s inter puff interval, the average yields of formaldehyde, acetaldehyde, acrolein, propionaldehyde and methacrolein were 630, 2520, 892, 403, and 106 μg/smoking session, respectively. The results showed that none of the aldehydes identified in this study are found in the particulate phase of the smoke, except for formaldehyde for which the partitioning coefficient was estimated as K p = 3.3 × 10 -8 μg/m 3 . Given previously reported lung absorption fractions of circa 90% for volatile aldehydes, the yields measured in this study are sufficient to induce various diseases depending on the extent of exposure, and on the breathing patterns of the smokers.

The development and design of future internal combustion engines requires fundamental understanding and the capability to model the autoignition and pollutant formation behavior of petroleumbased and other fuels. Naphthenes are an important constituent of gasoline, and they can comprise larger portions of unconventionally-derived gasoline. There is a lack of data and validated models for 5-membered ring naphthenes. In this work, the autoignition characteristics of cyclopentane, and two of its substituted analogues, methylcyclopentane, and ethylcyclopentane are investigated using a twin-piston rapid compression machine. Each fuel is studied at engine-representative conditions: 20, 50 bar and 700-980 K, with mixtures containing stoichiometric fuel / oxygen ratios at various extents of dilution with inert gases.Negative temperature coefficient (NTC) behavior is observed for cyclopentane, though first-stage ignition and associated low temperature heat release behavior are only evident at temperatures below that for the transition to NTC. Pressure is found to have a larger impact on the reactivity than oxygen dilution, with both effects amplified in the NTC region. The cyclopentane experiments in this study are challenged by the sensitivity of this molecule to non-uniform, or mild ignition phenomena within the NTC region. The addition of saturated sidechains in methyl-and ethylcyclopentane significantly increases the reactivity of the molecules, especially at low temperature and NTC conditions. At the highest temperatures though, there is little difference between the three naphthenes. Typical two-stage ignition behavior is observed across a wide range of temperatures for these alkyl cyclopentanes with no mild ignition observed within the NTC region.A recently developed model for cyclopentane is extended to include reactions for methylcyclopentane, and this is used to simulate the new experiments. The simulation results indicate that low temperature reactivity of cyclopentane is dominated by HO2 elimination of the RO2 species producing cyclopentene, and this inhibits autoignition since it is a very stable molecule. When a methyl group is substituted on the ring, additional RO2 isomerization pathways are available, and these substantially increase the fuel reactivity. HO2 elimination is also important with methylcyclopentane, and this leads to significant production of cyclic olefins 3 which can further react to produce diolefins. These findings are consistent with observations that have been made in other experimental apparatuses.

No abstract

Non-toxic organosilicon coatings with hydrophobic properties were deposited on Kraft paper films using atmospheric-pressure dielectric barrier discharge. In order to assess the applicability of the plasma-deposited coating in the food packaging industry, its stability in different liquids (i.e., food simulants) was studied. Chemical analyses reveal that the food simulants, namely, de-ionized water, acetic acid, ethanol, and heptane, do not significantly alter the chemical composition or the hydrophobicity of the coatings. Based on inductively coupled plasma-optical emission spectroscopy analyses, the amount of Si released from the plasma-deposited coating is less than that typically detected in tap water. Overall, the results obtained suggest that hydrophobic plasma-deposited organosilicon coatings have great potential for use in food and wet packaging applications, especially considering their environmentally friendly character.