Development of efficient and low-cost methods for the production of cobalt and cobalt oxide nanoparticles is of great interest. Such nanoparticles are typically prepared via transformation of precursors under controlled conditions. In the case of organic precursors, the production of said nanoparticles takes place through thermal decomposition of the organic moiety. The decomposition pathway of the precursor is greatly dependent on the type (i.e. inert, reducing or oxidizing) of the gaseous atmosphere prevailing during heating, as well as on the heating schedule itself. The characteristics of the organic group have also an important influence on the structure of the final material. The goal of the current work is to present a comprehensive review of the research work focusing on the synthesis of cobalt-based nanomaterials from activation of organic precursors.

No abstract

The depletion of fossil energy sources and the legislation regarding emission control demand the use of alternative fuels and rapid progression of aftertreatment technologies. The study of dimethyl ether (DME) catalytic oxidation is important in this respect, as DME is a promising clean fuel and at the same time a VOC pollutant present in the tail gases of industrial processes. In the present work, copper ferrite catalysts synthesized via the citrate complexation method have been evaluated in DME oxidation. N2-physisorption, XRD, H2-TPR, and XPS were employed for the characterization of the mixed oxide catalysts. The copper ferrite spinel phase was detected in all samples accompanied by a gradual decrease in the bulk CuO phase upon increase in iron content, with the latter never vanishing completely. The Fe0.67Cu0.33 catalyst exhibited the highest catalytic activity in DME oxidation, attaining approximately a 4-fold higher oxidation rate compared to the respective pure copper and iron oxides. The enhanced catalytic performance was attributed to the higher specific surface area of the catalyst and its enhanced redox properties. Highly dispersed copper species were developed owing to the formation of the spinel phase. DME-TPD/TPSR experiments showed that the surface lattice oxygen of the Fe0.67Cu0.33 catalyst can oxidize preadsorbed DME at a lower temperature than all other catalysts which is in agreement with the H2-TPR findings.

Dimethyl ether (DME) is considered an alternative hydrogen carrier with potential use in fuel cells and automotive and domestic applications. Dimethyl ether hydrolysis to methanol is a thermodynamically limited reaction catalyzed by solid-acid catalysts, mainly Al2O3 and zeolites. Moreover, it is the rate-limiting step of the DME steam reforming reaction, which is employed for the production of hydrogen fuel for fuel cell feeding. In the present study, the performance of WO3/Al2O3 catalysts (0–44% wt. WO3) was tested in DME hydrolysis reaction. The catalysts were characterized by means of N2-physisorption, XRD, Raman spectroscopy, XPS, NH3-TPD and 2,6-di-tert-butylpyridine adsorption experiments. The reaction rate of DME hydrolysis exhibited a volcanic trend as a function of tungsten surface density, while the best-performing catalyst was 37WO3/Al2O3, with a tungsten surface density of 7.4 W/nm2, noting that the theoretical monolayer coverage for the specific system is 4–5 W/nm2. Brønsted acidity was directly associated with the catalytic activity, following the same volcanic trend as a function of tungsten surface density. Blocking of Brønsted acid sites with 2,6-di-tert-butylpyridine led to a dramatic decrease in hydrolysis rates by 40 times, proving that Brønsted acid sites are primarily responsible for the catalytic activity. Thus, the type and strength rather than the concentration of acid sites are the key factors influencing the catalytic activity.

No abstract