The following monopositive actinyl ions were produced by electrospray ionization of aqueous solutions of An(VI)O(2)(ClO(4))(2) (An = U, Np, Pu): U(V)O(2)(+), Np(V)O(2)(+), Pu(V)O(2)(+), U(VI)O(2)(OH)(+), and Pu(VI)O(2)(OH)(+); abundances of the actinyl ions reflect the relative stabilities of the An(VI) and An(V) oxidation states. Gas-phase reactions with water in an ion trap revealed that water addition terminates at AnO(2)(+)·(H(2)O)(4) (An = U, Np, Pu) and AnO(2)(OH)(+)·(H(2)O)(3) (An = U, Pu), each with four equatorial ligands. These terminal hydrates evidently correspond to the maximum inner-sphere water coordination in the gas phase, as substantiated by density functional theory (DFT) computations of the hydrate structures and energetics. Measured hydration rates for the AnO(2)(OH)(+) were substantially faster than for the AnO(2)(+), reflecting additional vibrational degrees of freedom in the hydroxide ions for stabilization of hot adducts. Dioxygen addition resulted in UO(2)(+)(O(2))(H(2)O)(n) (n = 2, 3), whereas O(2) addition was not observed for NpO(2)(+) or PuO(2)(+) hydrates. DFT suggests that two-electron three-centered bonds form between UO(2)(+) and O(2), but not between NpO(2)(+) and O(2). As formation of the UO(2)(+)-O(2) bonds formally corresponds to the oxidation of U(V) to U(VI), the absence of this bonding with NpO(2)(+) can be considered a manifestation of the lower relative stability of Np(VI).

Several lanthanide and actinide tetranitrate ions, M(III)(NO3)4(-), were produced by electrospray ionization and subjected to collision induced dissociation in quadrupole ion trap mass spectrometers. The nature of the MO(NO3)3(-) products that result from NO2 elimination was evaluated by measuring the relative hydrolysis rates under thermalized conditions. Based on the experimental results it is inferred that the hydrolysis rates relate to the intrinsic stability of the M(IV) oxidation states, which correlate with both the solution IV/III reduction potentials and the fourth ionization energies. Density functional theory computations of the energetics of hydrolysis and atoms-in-molecules bonding analysis of representative oxide and hydroxide nitrates substantiate the interpretations. The results allow differentiation between those MO(NO3)3(-) that comprise an O(2-) ligand with oxidation to M(IV) and those that comprise a radical O(-) ligand with retention of the M(III) oxidation state. In the particular cases of MO(NO3)3(-) for M = Pr, Nd and Tb it is proposed that the oxidation states are intermediate between M(III) and M(IV).

Hydration of ytterbium (III) halide/hydroxide ions produced by electrospray ionization was studied in a quadrupole ion trap mass spectrometer and by density functional theory (DFT). Gas-phase YbX 2? and YbX(OH)?(X = OH, Cl, Br, or I) were found to coordinate from one to four water molecules, depending on the ion residence time in the trap. From the time dependence of the hydration steps, relative reaction rates were obtained. It was determined that the second hydration was faster than both the first and third hydrations, and the fourth hydration was the slowest; this ordering reflects a combination of insufficient degrees of freedom for cooling the hot monohydrate ion and decreasing binding energies with increasing hydration number. Hydration energetics and hydrate structures were computed using two approaches of DFT. The relativistic scalar ZORA approach was used with the PBE functional and all-electron TZ2P basis sets; the B3LYP functional was used with the Stuttgart relativistic small-core ANO/ ECP basis sets. The parallel experimental and computational results illuminate fundamental aspects of hydration of f-element ion complexes. The experimental observations-kinetics and extent of hydration-are discussed in relationship to the computed structures and energetics of the hydrates. The absence of pentahydrates is in accord with the DFT results, which indicate that the lowest energy structures have the fifth water molecule in the second shell.

The gas-phase reactions of two dipositive actinide ions, Th(2+) and U(2+), with CH(4), C(2)H(6), and C(3)H(8) were studied by both experiment and theory. Fourier transform ion cyclotron resonance mass spectrometry was employed to study the bimolecular ion-molecule reactions; the potential energy profiles (PEPs) for the reactions, both observed and nonobserved, were computed by density functional theory (DFT). The experiments revealed that Th(2+) reacts with all three alkanes, including CH(4) to produce ThCH(2)(2+), whereas U(2+) reacts with C(2)H(6) and C(3)H(8), with different product distributions than for Th(2+). The comparative reactivities of Th(2+) and U(2+) toward CH(4) are well explained by the computed PEPs. The PEPs for the reactions with C(2)H(6) effectively rationalize the observed reaction products, ThC(2)H(2)(2+) and UC(2)H(4)(2+). For C(3)H(8) several reaction products were experimentally observed; these and additional potential reaction pathways were computed. The DFT results for the reactions with C(3)H(8) are consistent with the observed reactions and the different products observed for Th(2+) and U(2+); however, several exothermic products which emerge from energetically favorable PEPs were not experimentally observed. The comparison between experiment and theory reveals that DFT can effectively exclude unfavorable reaction pathways, due to energetic barriers and/or endothermic products, and can predict energetic differences in similar reaction pathways for different ions. However, and not surprisingly, a simple evaluation of the PEP features is insufficient to reliably exclude energetically favorable pathways. The computed PEPs, which all proceed by insertion, were used to evaluate the relationship between the energetics of the bare Th(2+) and U(2+) ions and the energies for C-H and C-C activation. It was found that the computed energetics for insertion are entirely consistent with the empirical model which relates insertion efficiency to the energy needed to promote the An(2+) ion from its ground state to a prepared divalent state with two non-5f valence electrons (6d(2)) suitable for bond formation in C-An(2+)-H and C-An(2+)-C activated intermediates.

Gas-phase organoactinyl complexes possessing discrete An−C bonds (An = U, Np, Pu) were synthesized in a quadrupole ion trap by endothermic decarboxylation of [AnO 2 (O 2 C−R) 3 ]− anion complexes in which a formally AnO 2 2+ actinyl core is coordinated by three carboxylate ligands, with R = CH 3 (methyl), CH 3 CC (1-propynyl), C 6 H 5 (phenyl), C 6 F 5 (pentafluorophenyl). Decarboxylation and competing ligand loss were studied computationally by density functional theory complementing experiment. Although decarboxylation was computed to be the energetically most favorable process in all cases, reduction from An(VI) to An(V) via neutral ligand loss was often prevalent, particularly for An = Np, Pu, presumably resulting from barriers associated with decarboxylation. Comparative hydrolysis rates of the An−C bonds were experimentally determined, and the chemical properties of these bonds were analyzed by the quantum theory of atoms in molecules. The measured hydrolysis rates differed by up to 3 orders of magnitude: the fastest was for [(CH 3 CC)UO 2 (O 2 C− CCCH 3 ) 2 ]− and the slowest for [(C 6 F 5 )PuO 2 (O 2 C−C 6 F 5 ) 2 ]− . There is a general correlation between hydrolysis exothermicity and hydrolysis rate. Prototypical hydrolysis reaction pathways computed for R = CH 3 (An = U, Np) reveal a mechanism in which an outer-sphere water becomes inner-sphere concomitant with transfer of an H atom to yield an OH ligand and CH 4 , with a net energy release of 170 kJ mol −1 and a transition state barrier of 45 kJ mol −1 for An = U. Infrared multiphoton dissociation spectra of selected complexes were acquired to confirm the predicted structures by agreement between the computed and observed vibrational frequencies. The experiment and theory results provide an evaluation of the comparative propensities for formation of the organoactinyls as a function of actinide and carboxylate and an assessment of the nature and stability toward hydrolysis of the primarily ionic An−C bonds.

Gas-phase complexes of uranyl(V) ligated to anions X(-) (X = F, Cl, Br, I, OH, NO3, ClO4, HCO2, CH3CO2, CF3CO2, CH3COS, NCS, N3), [UO2X2](-), were produced by electrospray ionization and reacted with O2 in a quadrupole ion trap mass spectrometer to form uranyl(VI) anionic complexes, [UO2X2(O2)](-), comprising a superoxo ligand. The comparative rates for the oxidation reactions were measured, ranging from relatively fast [UO2(OH)2](-) to slow [UO2I2](-). The reaction rates of [UO2X2](-) ions containing polyatomic ligands were significantly faster than those containing the monatomic halogens, which can be attributed to the greater number of vibrational degrees of freedom in the polyatomic ligands to dissipate the energy of the initial O2-association complexes. The effect of the basicity of the X(-) ligands was also apparent in the relative rates for O2 addition, with a general correlation between increasing ligand basicity and O2-addition efficiency for polyatomic ligands. Collision-induced dissociation of the superoxo complexes showed in all cases loss of O2 to form the [UO2X2](-) anions, indicating weaker binding of the O2(-) ligand compared to the X(-) ligands. Density functional theory computations of the structures and energetics of selected species are in accord with the experimental observations.

Activation of CO2 is demonstrated by its spontaneous dissociative reaction with the gas-phase anion complex NUOCl2(-), which can be considered as NUO(+) coordinated by two chloride anion ligands. This reaction was previously predicted by density functional theory to occur exothermically, without barriers above the reactant energy. The present results demonstrate the validity of the prediction of microscopic reversibility, and provide a rare case of spontaneous dissociative addition of CO2 to a gas-phase complex. The activation of CO2 by NUOCl2(-) proceeds by conversion of a U[triple bond, length as m-dash]N bond to a U[double bond, length as m-dash]O bond and creation of an isocyanate ligand to yield the complex UO2(NCO)Cl2(-), in which uranyl, UO2(2+), is coordinated by one isocyanate and two chloride anion ligands. This activation of CO2 by a uranium(vi) nitride complex is distinctive from previous reports of oxidative insertion of CO2 into lower oxidation state U(iii) or U(iv) solid complexes, during which both C-O bonds remain intact. This unusual observation of spontaneous addition and activation of CO2 by NUOCl2(-) is a result of the high oxophilicity of uranium. If the computed Gibbs free energy of the reaction pathway, rather than the energy, is considered, there are barriers above the reactant asymptotes such that the observed reaction should not proceed under thermal conditions. This result provides a demonstration that energy rather than Gibbs free energy determines reactivity under low-pressure bimolecular conditions.

In this work, we report results of calculations based on the density functional theory (B3LYP/6-311+G(2d,2p)) of different species containing a terminal cyaphide bond. The chosen species range from small molecules and anions (C⋮P(-), HC⋮P, tBuC⋮P, [(CF3)3BC⋮P)](-)) to large transition-metal containing complexes ([(dppe)2Ru(H)(C⋮P)], trans-[Pt(PMe3)2(Cl)(C⋮P)], trans-[Pt(PMe3)2(Cl)(CP)Pt(PMe3)2]). A comparative analysis of the description of the C⋮P bond obtained by different methodologies is presented. Topological analyses of the electron density in the framework of the theory of atoms in molecules (AIM) and of the electron localization function (ELF) are complemented with the results obtained by natural bond orbital analysis (NBO).