Spectral reflectance data originating from Unmanned Aerial Vehicle (UAV) imagery is a valuable tool to monitor plant nutrition, reduce nitrogen (N) application to real needs, thus producing both economic and environmental benefits. The objectives of the trial were i) to compare the spectral reflectance of 3 turfgrasses acquired via UAV and by a ground-based instrument; ii) to test the sensitivity of the 2 data acquisition sources in detecting induced variation in N levels. N application gradients from 0 to 250 kg ha-1 were created on 3 different turfgrass species: Cynodon dactylon x transvaalensis (Cdxt) ‘Patriot’, Zoysia matrella (Zm) ‘Zeon’ and Paspalum vaginatum (Pv) ‘Salam’. Proximity and remote-sensed reflectance measurements were acquired using a GreenSeeker handheld crop sensor and a UAV with onboard a multispectral sensor, to determine Normalized Difference Vegetation Index (NDVI). Proximity-sensed NDVI is highly correlated with data acquired from UAV with r values ranging from 0.83 (Zm) to 0.97 (Cdxt). Relating NDVI-UAV with clippings N, the highest r is for Cdxt (0.95). The most reactive species to N fertilization is Cdxt with a clippings N% ranging from 1.2% to 4.1%. UAV imagery can adequately assess the N status of turfgrasses and its spatial variability within a species, so for large areas, such as golf courses, sod farms or race courses, UAV acquired data can optimize turf management. For relatively small green areas, a hand-held crop sensor can be a less expensive and more practical option.

No abstract

Autonomous mowers are battery-powered machines designed for lawn mowing that require very low human labour. Autonomous mowers can increase turf quality and reduce local noise and pollution compared with gasoline-powered rotary mowers. However, very little is known about the effects of autonomous mowing on encroaching weeds. The aim of this research was to compare the effects of an autonomous mower and an ordinary gasoline-powered mower on weed development in an artificially infested tall fescue (Festuca arundinacea Schreb.) turf with different nitrogen (N) rates. A three-way factor experimental design with three replications was adopted. Factor A consisted of three N rates (0, 75, and 150 kg ha −1 ), factor B consisted of two mowing systems (autonomous mower vs. walk-behind gasoline rotary mower equipped for mulching), and factor C which consisted of four different transplanted weed species: (a) Bellis perennis L., (b) Trifolium repens L.; (c) Trifolium subterraneum L.; and (d) Lotus corniculatus L. Of these, B. perennis is a rosette-type plant, while the other three species are creeping-type plants. The interaction between mowing system and transplanted weed species showed that the four transplanted weed species were larger when mowed by the autonomous mower than by the rotary mower. The autonomous mower yielded larger weeds probably because the constant mowing height caused the creeping weed species to grow sideways, since the turfgrass offered no competition for light. N fertilization increased turf quality and mowing quality, and also reduced spontaneous weed infestation. Autonomous mowing increased turf quality, mowing quality, but also the percentage of spontaneous weed cover.

No abstract

Battery-powered autonomous mowers are designed to reduce the need of labor for lawn mowing compared with traditional endothermic engine mowers and at the same time to abate local emissions and noise. The aim of this research was to compare autonomous mower with traditional rotary mower on a tall fescue (Festuca arundinacea) lawn under different nitrogen (N) rates. A two-way factor experimental design with three replications was adopted. In the study, four N rates (0, 50, 100, and 150 kg·ha−1) and two mowing systems (autonomous mower vs. gasoline-powered walk-behind rotary mower equipped for mulching) were used. As expected, N fertilization increased turf quality. At the end of the trial, the autonomous mower increased turf density (3.2 shoots/cm2) compared with the rotary mower (2.1 shoots/cm2) and decreased average leaf width (2.1 mm) compared with the rotary mower (2.7 mm). Increased density and decreased leaf width with autonomous mowing yielded higher quality turf (7.3) compared with the rotary mower (6.4) and a lower weed incidence (6% and 9% cover for autonomous mower and rotary mower, respectively). Disease incidence and mowing quality were unaffected by the mowing system. The autonomous mower working time was set to 10 hours per day (≈7.8 hours for mowing and 2.2 hours for recharging) for a surface of 1296 m2. The traditional rotary mower working time for the same surface was 1.02 hours per week. The estimated primary energy consumption for autonomous mower was about 4.80 kWh/week compared with 12.60 kWh/week for gasoline-powered rotary mowing. Based on turf quality aspects and energy consumption, the use of autonomous mowers could be a promising alternative to traditional mowers.