The technical requirements for naval ships machine foundations are far more strict in comparison to merchant’s vessels. These requirements are confirmed in the military standardization of many countries. Underwater Explosion (UNDEX phenomena) detonation pulses, force naval engineers to design and implement different shock absorbers made from a wide variety of materials. This study presents the tests results of typical shock absorber designs made of various types of rubber and elastomers. The initial objective of the study was to determine the energy absorption of shock impacts, the choice of materials capable of operating within the temperature range of 0 °C to 70 °C, resistance to contact with oils and marine fuel, performance at frequencies ranging from 5 to 30,000 Hz, and absorption no less than 40% of harmonic vibration energy. Initial studies conducted on tensile testing machine were used to determine the static and dynamic stiffness of a shock absorbers. Considerations of stiffness coefficient for the linear and nonlinear range is typical for shock pulses. Further tests were carried out on a lightweight drop hammer to determine the characteristics of the damping coefficient for high-speed wave interactions—Shock Response Spectrum (SRS). The final aim of the study was to assess the repeatability of the shock absorbers response to multiple impact loads. Mechanical properties describing possibilities of tested dampers materials to absorb energy of UNDEX were also presented.

No abstract

This article presents the possibility of evaluating the technical condition of common rail fuel systems injectors using the vibration method. The other most successful methods of diagnosing the common rail injectors were described. Marine diesel engine common rail injection installations had been characterised. Results of tests obtained during vibration measurements were presented as well. The results confirm the possibility of determining the technical condition of modern diesel engines injectors without the need of engine stopping. The results are especially important for marine engines without indicating cocks or thermoelements allowing measurements of exhaust gases temperature on each cylinder.

Rubber and rubber-metal vibration isolators are widely used vibration isolation systems in marine applications. For naval application, shock absorber mounting systems must fulfil two functions. The first one supports the suspended mass in the absence of waving or detonation while providing isolation from vibrations and shock impact. In the second case, during the machine operation, it reduces the force of movement to an acceptable value. Moreover, it returns the insulated mass to the position output without plastic deformation or residual buckling after removing shock stresses or harmonic vibrations. The environment in which marine vibration isolators are to be used strongly influences the selection of a shock absorber. The main environmental problem is the temperature range in marine power plants, which ranges from 20 °C to 55 °C. Temperature fluctuations may cause changes in the physical properties of typical vibration/shock insulators. Both rubbers and elastomers used for shock absorbers tend to stiffen, gain low-temperature damping, and soften and lose damping at elevated temperatures. Factors such as moisture, ozone and changes in atmospheric pressure are usually ignored in shipbuilding. The main environmental factors influencing the ageing of insulators are liquid saturated hydrocarbons, i.e., oils, fuels, coolants, etc., which may come into contact with the surface of the insulators. This work presents the results of the research carried out to determine the effect of overload and the impact of petroleum products on the materials of metal-rubber shock absorbers made of three different rubbers and one polyurethane mixture. For each of the materials, shock absorbers with three different degrees of hardness were tested.

The paper presents a results of vibration tests of common rail injectors operating in diesel engines. The most common methods of diagnosing common rail injectors (CR) as well as the most common damage of injectors of this type have been described. The results and analyzes of tests obtained during measurements on two different test stands were presented. Obtained results allowed for the preliminary determination of diagnostically sensitive parameters, which may allow the development of the injector diagnostics method without the need to stopping the engine.