Durum wheat is one of the most important cereal grains worldwide, used mostly for pasta making and bakery products. The by-products derived for the milling process, although very abundant, have only limited use. The aim of this work was to characterize the oils extracted from the by-products of debranning (DP) and milling processes (MP) of durum wheat and to follow the changes due to the refining process on the minor components. The results showed that DP had significantly higher oil content than MP, but it was characterized by a significantly lower amount of tocols. Polyunsaturated fatty acids content was similar (around 62% of total fatty acids). Consequently, a mixture of DP/MP (60/40 w/w) was chosen as a basis for further studies concerning the refining process. During refining, carotenoids almost disappeared while tocols were reduced by 24% on average. Free fatty acids, peroxide value, and oxidized triacylglycerols were significantly reduced by refining, while triacylglycerol oligopolymers were significantly higher than the crude oil. Durum wheat oil had an outstanding content of phytosterols and policosanols. Overall, the edible oil obtained from durum wheat after refining could be considered a good source of phytochemicals and could represent a valuable strategy to valorize the by-products from durum wheat mills.

Lipids play an important role in defining the overall quality of biscuits, particularly in terms of resistance to oxidation, as well as for their influence on textural and sensorial properties. The aim of this work was to investigate the effects of durum wheat oil on the physico-chemical and sensory features of biscuits. Control biscuits (C) prepared with the commonly used sunflower oil were compared with samples prepared with durum wheat oil at 50% (D50) and 100% replacement levels (D100). The reformulated biscuits were very rich in tocols, especially tocotrienols (982.9, 635.2, and 64.1 mg/kg on lipid fraction weight in D100, D50, and C, respectively). The higher content of antioxidants extended the resistance to the oxidation of biscuits (induction time = 53.61, 70.87, and 79.92 h in C, D50, and D100, respectively). D100 showed the lowest amounts of triacylglycerol oligopolymers and oxidized triacylglycerols, and the lowest amounts of the volatile markers of lipid oxidation (hexanal and nonanal). The use of durum wheat oil did not affect the sensorial and textural properties, compared to C. This study suggests that durum wheat oil could be effectively used in biscuit-making to decrease the oxidative phenomena and increase the bioactives of the end-products.

Wheat germ (WG)’s shelf life after the milling process is incredibly short because of the presence of enzymes that aggravate the oxidation process; thus, stabilization is required in order to exploit the nutrients and bioactive compounds within WG. The critical point for the oxidation process is the mechanical treatment used to separate WG from the kernel, which exposes the lipid fraction to the air. Showing the connection between the quality of durum wheat, considering its storage management, and wheat germ oil (WGO), extracted with a cold press, solvent and supercritical CO2, is the aim of the study. The acidity and peroxide values were analyzed to evaluate lipid oxidation, while fatty acids, tocols, sterols and policosanols were evaluated for WGO characterization. The first fundamental step to control lipid oxidation is raw material management. Subsequently, the tempering phase of durum wheat, which is applied before the degermination process, is the most critical point for oxidation to develop because of the increase in moisture in the caryopsis and the activation of lipase and lipoxygenase. This represents a paradox: in order to stabilize the germ with degermination, first it seems inevitable to carry out a process that destabilizes it. To retains its highest quality, this will lead to a better use of the whole grain by reducing WG and by-product waste.

No abstract