Myosin produces force in a cyclic interaction, which involves alternate tight binding to actin and to ATP. We have investigated the energetics associated with force production by measuring the force generated by skinned muscle fibers as the strength of the actomyosin bond is changed. We varied the strength of the actomyosin bond by addition of a polymer that promotes protein-protein association or by changing temperature or ionic strength. We estimated the free energy available to generate force by measuring isometric tension, as the free energy of the states that precede the working stroke are lowered with increasing phosphate. We found that the free energy available to generate force and the force per attached cross-bridge at low [Pi] were both proportional to the free energy available from the formation of the actomyosin bond. We conclude that the formation of the actomyosin bond is involved in providing the free energy driving the production of isometric tension and mechanical work. Because the binding of myosin to actin is an endothermic, entropically driven reaction, work must be performed by a "thermal ratchet" in which a thermal fluctuation in Brownian motion is captured by formation of the actomyosin bond.

The role played by ADP in modulating cross-bridge function has been difficult to study, because it is hard to buffer ADP concentration in skinned muscle preparations. To solve this, we used an analog of ADP, spin-labeled ADP (SL-ADP). SL-ADP binds tightly to myosin but is a very poor substrate for creatine kinase or pyruvate kinase. Thus ATP can be regenerated, allowing well-defined concentrations of both ATP and SL-ADP. We measured isometric ATPase rate and isometric tension as a function of both [SL-ADP], 0.1-2 mM, and [ATP], 0.05-0.5 mM, in skinned rabbit psoas muscle, simulating fresh or fatigued states. Saturating levels of SL-ADP increased isometric tension (by P'), the absolute value of P' being nearly constant, approximately 0.04 N/mm(2), in variable ATP levels, pH 7. Tension decreased (50-60%) at pH 6, but upon addition of SL-ADP, P' was still approximately 0.04 N/mm(2). The ATPase was inhibited competitively by SL-ADP with an inhibition constant, K(i), of approximately 240 and 280 microM at pH 7 and 6, respectively. Isometric force and ATPase activity could both be fit by a simple model of cross-bridge kinetics.

We have used polyethylene glycol (PEG) to perturb the actomyosin interaction in active skinned muscle fibers. PEG is known to potentiate protein-protein interactions, including the binding of myosin to actin. The addition of 5% w/v PEG (MW 300 or 4000) to active fibers increased fiber tension and decreased shortening velocity and ATPase activity, all by 25-40%. Variation in [ADP] or [ATP] showed that the addition of PEG had little effect on the dissociation of the cross-bridge at the end of the power stroke. Myosin complexed with ADP and the phosphate analog V(i) or AlF(4) binds weakly to actin and is an analog of a pre-power-stroke state. PEG substantially enhances binding of these states both in active fibers and in solution. Titration of force with increasing [P(i)] showed that PEG increased the free energy available to drive the power stroke by about the same amount as it increased the free energy available from the formation of the actomyosin bond. Thus PEG potentiates the binding of myosin to actin in active fibers, and it provides a method for enhancing populations of some states for structural or mechanical studies, particularly those of the normally weakly bound transient states that precede the power stroke.

We have investigated the effects of a stronger actomyosin bond on force (Ps) during rapid stretch of active permeabilized rabbit psoas muscle fibers as a function of temperature from 5 to 30 degrees C. The strength of the actomyosin bond is enhanced by addition of polyethylene glycol (PEG), especially in pre-powerstroke states [Chinn et al. (2000) Biophys J 49: 437-451]. We have hypothesized that such states produce much of the force when activated muscles are stretched [Getz et al. (1998) Biophys J 75: 2971-2983]. Addition of PEG to activated fibers produced a small increase in isometric tension, Po (50-90 kN/m2), which was approximately independent of temperature. In contrast PEG produced a dramatic increase in Ps at low temperatures (200-300 kN/m2), but a modest increase at higher temperatures (70-90 kN/m2). We also measured Ps and Po in solutions containing the phosphate analog aluminum fluoride (AlF4) with and without PEG. In the absence of PEG, AlF4 reduced Po much more than Ps. Addition of PEG did not enhance Po, but enhanced Ps significantly. The contrasting effects of PEG on Ps and Po, and the effect of temperature can be explained by a model in which stretch force is produced by pre-powerstroke cross-bridges whose maximum distension is increased by PEG, and isometric force is produced by strongly bound cross-bridges whose bond strength is also enhanced by PEG, but to a lesser extent.