Owing to the excellent sensitivity to gases, metal-oxide semiconductors (MOS) are widely used as materials for gas sensing. Usually, MOS gas sensors have some common shortages, such as relatively poor selectivity and high operating temperature. Graphene has drawn much attention as a gas sensing material in recent years because it can even work at room temperature, which reduces power consumption. However, the low sensitivity and long recovery time of the graphene-based sensors limit its further development. The combination of metal-oxide semiconductors and graphene may significantly improve the sensing performance, especially the selectivity and response/recovery rate at room temperature. In this review, we have summarized the latest progress of graphene/metal-oxide gas sensors for the detection of NO2, NH3, CO and some volatile organic compounds (VOCs) at room temperature. Meanwhile, the sensing performance and sensing mechanism of the sensors are discussed. The improved experimental schemes are raised and the critical research directions of graphene/metal-oxide sensors in the future are proposed.

No abstract

No abstract

No abstract

Abstract-We demonstrate a novel, highly sensitive integrated hydrogen sensor based on a silicon ring resonator on the silicon-oninsulator platform. The hydrogen sensitive element in the sensor structure is a platinum-doped tungsten oxide catalytic coating. The catalytic combustion of hydrogen in air leads to a local temperature rise in the ring resonator. The resulting thermo-optic effect shifts the ring resonator resonance. Resonance wavelength shifts higher than a nanometer are measured for hydrogen concentrations below the 4% lower explosion limit. A potentially tunable sensitivity of around 480 pm shift per %H 2 is achieved at an operating temperature of about 40 C.

No abstract

Using hydrogen as fuel presents a potential risk of explosion and requires low cost and efficient leak sensors. We present here a hybrid sensor configuration consisting of a long period fiber grating (LPFG) and a superimposed uniform fiber Bragg grating (FBG). Both gratings are covered with a sensitive layer made of WO(3) doped with Pt on which H(2) undergoes an exothermic reaction. The released heat increases the temperature around the gratings. In this configuration, the LPFG favors the exothermic reaction thanks to a light coupling to the sensitive layer while the FBG reflects the temperature change linked to the hydrogen concentration. Our sensor is very fast and suitable to detect low hydrogen concentrations in air whatever the relative humidity level and for temperatures down to -50 degrees C, which is without equivalent for other hydrogen optical sensors reported so far.

No abstract