We demonstrate a 3.44 μm all-fiber laser emitting a maximum of 1.5 W at room temperature, the highest continuous power ever generated from a mid-IR fiber oscillator clearly beyond 3 μm. The laser operates on the 4F(9/2)→4I(9/2) transition of erbium-doped fluoride glasses and relies on a dual pumping scheme at 974 and 1976 nm. By combining a dichroic mirror deposited on the input fiber tip and a fiber Bragg grating as an output coupler, a stable laser emission is produced with a FWHM bandwidth of less than 0.6 nm. The laser cavity has an efficiency of 19% with respect to the launched pump power at 1976 nm and no saturation is observed provided 974 nm co-pumping is sufficient. The joint effect of the two pumps is also investigated.

The technique of cathodic ac dual magnetron sputtering along with the high energy ionic bombardment is known to yield high-quality thin films in terms of their uniformity and high density. This technique has been applied for the first time to achieve thermochromic VO2 thin films that show a high optical and electrical contrast between normal and switched states. In this two-step process Vanadium metal films were deposited and subsequently oxidized in optimum conditions to achieve stoichiometric VO2 films. Typical films switched between more than 40 % to less than 5 % transmission in the infrared region while undergoing an electrical sheet resistance change between 1 × 10(5) and 1 × 10(2) Ω/cm(2). The application potential of such VO2 films in integrated optics is deemed high.

No abstract

The emission of a broad-area laser always contains several lateral modes (along the junction plane) even at low drive levels. To increase the discrimination against high-order lateral modes, we developed simple techniques for depositing a profiled thin layer of SiO on the output facet of a broad-area laser that has a 75-μm-wide injection current stripe. The profiled coating provided a nearly Gaussian reflectivity in the lateral direction (parallel to the junction plane). The resolved near-field spectra of the uncoated and coated lasers have been compared. The maximum output power in the single-lateral-mode regime was pushed to 25 mW with the profiled coating, compared with a corresponding power of less than 1 mW before deposition. Experimental results have confirmed the behavior predicted by our numerical simulations. This method is scalable to higher-power lasers.

One third of fatal car accidents and so many tragedies are due to alcohol abuse. These sad numbers could be mitigated if everyone had access to a breathalyzer anytime and anywhere. Having a breathalyzer built into a phone or wearable technology could be the way to get around reluctance to carry a separate device. With this goal, we propose an inexpensive breathalyzer that could be integrated in the screens of mobile devices. Our technology is based on the evaporation rate of the fog produced by the breath on the phone screen, which increases with increasing breath alcohol content. The device simply uses a photodiode placed on the side of the screen to measure the signature of the scattered light intensity from the phone display that is guided through the stress layer of the Gorilla glass screen. A part of the display light is coupled to the stress layer via the evanescent field induced at the edge of the breath microdroplets. We demonstrate that the intensity signature measured at the detector can be linked to blood alcohol content. We fabricated a prototype in a smartphone case powered by the phone’s battery, controlled by an application installed on the smartphone, and tested it in real-world environments. Limitations and future work toward a fully operational device are discussed.