Additive manufacturing of components has increased significantly in capacity; additional post-processes are usually required in order to use the components. A milling process is often used to create functional surfaces. The paper shows whether the additive manufacturing process has an influence on the milling process. For this purpose, additive manufacturing processes using powder and laser (SLM), powder and arc (3DPMD), as well as wire and arc (WAAM) of the same material are compared. Based on the microstructure and the different mechanical properties, the component properties are compared with each other and with conventional sheet metal. For this purpose, samples are cut from additively manufactured components and milled under identical conditions. The temperature and the milling forces are measured and evaluated. It is shown that the additive manufacturing process results in significant differences in machinability and that the mechanical properties alone do not provide sufficient information about the machinability.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.