The purpose of the present study was to develop intranasal delivery systems of sumatriptan using thermoreversible polymer Pluronic F127 (PF127) and mucoadhesive polymer Carbopol 934P (C934P). Formulations were modulated so as to have gelation temperature below 34°C to ensure gelation at physiological temperature after intranasal administration. Gelation temperature was determined by physical appearance as well as by rheological measurement. The gelation temperatures of the formulations decreased by addition of increasing concentrations of Carbopol (ie, from 29°C for 18% PF127 to 23.9°C for 18% PF127, 0.5% Carbopol). The mucoadhesive force in terms of detachment stress, determined using sheep nasal mucosal membrane, increased with increasing concentration of Carbopol. The results of in vitro drug permeation studies across sheep nasal mucosa indicate that effective permeation coefficient could be significantly increased by using in situ gelling formulation with Carbopol concentration 0.3% or greater. Finally, histopathological examination did not detect any damage during in vitro permeation studies. In conclusion, the PF127 gel formulation of sumatriptan with in situ gelling and mucoadhesive properties with increased permeation rate is promising for prolonging nasal residence time and thereby nasal absorption.

The main purpose of this work was to develop an oral microemulsion formulation for enhancing the bioavailability of acyclovir. A Labrafac-based microemulsion formulation with Labrasol as surfactant and Plurol Oleique as cosurfactant was developed for oral delivery of acyclovir. Phase behavior and solubilization capacity of the microemulsion system were characterized, and in vivo oral absorption of acyclovir from the microemulsion was investigated in rats. A single isotropic region, which was considered to be a bicontinuous microemulsion, was found in the pseudoternary phase diagrams developed at various Labrasol:Plurol Oleique:Labrafac ratios. With the increase of Labrasol concentration, the microemulsion region area and the amount of water and Labrafac solubilized into the microemulsion system increased; however, the increase of Plurol Oleique percentage produced opposite effects. The microemulsion system was also investigated in terms of other characteristics, such as interfacial tension, viscosity, pH, refractive index, diffusion, and bioavailability. Acyclovir, a poorly soluble drug, displayed high solubility in a microemulsion formulation using Labrafac (10%), Labrasol (32%), Plurol Oleique (8%), and water (50%). The in vitro intraduodenal diffusion and in vivo study revealed an increase of bioavailability (12.78 times) after oral administration of the microemulsion formulation as compared with the commercially available tablets.

b s t r a c tDapivirine mucoadhesive gels and freeze-dried tablets were prepared using a 3 × 3 × 2 factorial design. An artificial neural network (ANN) with multi-layer perception was used to investigate the effect of hydroxypropyl-methylcellulose (HPMC): polyvinylpyrrolidone (PVP) ratio (X1), mucoadhesive concentration (X2) and delivery system (gel or freeze-dried mucoadhesive tablet, X3) on response variables; cumulative release of dapivirine at 24 h (Q 24 ), mucoadhesive force (F max ) and zero-rate viscosity. Optimisation was performed by minimising the error between the experimental and predicted values of responses by ANN. The method was validated using check point analysis by preparing six formulations of gels and their corresponding freeze-dried tablets randomly selected from within the design space of contour plots. Experimental and predicted values of response variables were not significantly different (p > 0.05, two-sided paired t-test). For gels, Q 24 values were higher than their corresponding freeze-dried tablets. F max values for freeze-dried tablets were significantly different (2-4 times greater, p > 0.05, twosided paired t-test) compared to equivalent gels. Freeze-dried tablets having lower values for X1 and higher values for X2 components offered the best compromise between effective dapivirine release, mucoadhesion and viscosity such that increased vaginal residence time was likely to be achieved.

No abstract

6-mercaptopurine (6-MP) is a purine analogue used in childhood leukemia. Because of the oral bioavailability of 6-MP is low and highly variable, the aim of this study was to develop a new parenteral formulation that can prolong the biological half-life of the drug, improve its therapeutic efficacy, and its associated reduce side effects. Conventional and stealth 6-MP liposomes were prepared by a thin film hydration technique followed by a high-pressure homogenization process and characterized for percent entrapment efficiency (%EE), particle size, and stability in human plasma. Pharmacokinetic, tissue distribution, and biochemical analysis were performed after intravenous (IV) administration of all formulations of 6-MP on rats. The conventional liposomes were found less stable than stealth liposomes in human plasma at 37 degrees C. Stealth liposomes exhibited high peak plasma concentration (C(max)), and long circulating capacity in blood and biological half-life. The uptake of stealth liposomes by the liver and spleen and accumulation in the kidney were significantly less than that of conventional liposomes and the free drug. Serum urea, creatinine, GOT (Glutamic Oxaloacetic Transaminase), and GPT (Glutamic Pyruvic Transaminase) increased significantly in rats given an IV injection of conventional liposomes and the free drug, but not in those administered with the same dose of stealth liposomes. Stealth liposomes may help to increase therapeutic efficacy of 6-MP and to reduce total amount of dose as well as frequency of the dose. It also may reduce the possibility of the risk of toxicity to the liver and kidney generally associated with free 6-MP.