This critical review discusses specific chemical and physicochemical requirements which must be met for organic compounds to be considered as promising materials for applications in organic electronics. Although emphasis is put on molecules and macromolecules suitable for fabrication of field effect transistors (FETs), a large fraction of the discussed compounds can also be applied in other organic or hybrid (organic-inorganic) electronic devices such as photodiodes, light emitting diodes, photovoltaic cells, etc. It should be of interest to chemists, physicists, material scientists and electrical engineers working in the domain of organic electronics (423 references).

This critical review is devoted to semiconducting and high spin polymers which are of great scientific interest in view of further development of the organic electronics and the emerging organic spintronic fields. Diversified synthetic strategies are discussed in detail leading to high molecular mass compounds showing appropriate redox (ionization potential (IP), electron affinity (EA)), electronic (charge carrier mobility, conductivity), optoelectronic (electroluminescence, photoconductivity) and magnetic (magnetization, ferromagnetic spin interactions) properties and used as active components of devices such as n- and p-channel field effect transistors, ambipolar light emitting transistors, light emitting diodes, photovoltaic cells, photodiodes, magnetic photoswitches, etc. Solution processing procedures developed with the goal of depositing highly ordered and oriented films of these polymers are also described. This is completed by the description of principal methods that are used for characterizing these macromolecular compounds both in solution and in the solid state. These involve various spectroscopic methods (UV-vis-NIR, UPS, pulse EPR), electrochemistry and spectroelectrochemistry, magnetic measurements (SQUID), and structural and morphological investigations (X-ray diffraction, STM, AFM). Finally, four classes of polymers are discussed in detail with special emphasis on the results obtained in the past three years: (i) high IP, (ii) high |EA|, (iii) low band gap and (iv) high spin ones.

Using experimentally established sequence of extractions, we were able to fractionate regioregular poly(3-hexylthiophene) (R-P3HT) into four fractions differing significantly in their molecular weight (Mn) and exhibiting low polydispersity coefficients. 1H NMR analysis of low molecular fractions enabled us to propose the dominant chain termination mechanisms and identify the sources of regioregularity defects. In particular, it turned out that the presence of small amounts of undesired isomer of 2-bromo-3-hexylthiophene, namely, 2-bromo-4-hexylthiophene, strongly influences the molecular weight and to a much lesser extent the regioregularity of the polymer obtained via Grignard type polycondensation. In the reaction with the growing chain, 2-bromo-4-hexylthiophene either causes its termination, lowering in this manner the molecular weight of the resulting polymer, or introduces regioregularity defects of TT-HH (TT = tail to tail; HH = head to head) type. The average conjugation length in R-P3HT increases with the increase of Mn as manifested by a bathochromic shift of the lambdamax and the appearance of the vibrational structure in the UV-vis-near-IR spectra of the fractions of higher molecular weight. This conclusion is supported by FTIR data. The onset of the oxidative doping of R-P3HT shifts to lower potentials with the increase of the molecular weight as evidenced by cyclic voltammetry and UV-vis-near-IR spectroelectrochemistry.

The electrochemical properties of CdSe quantum dots with electrochemically inactive surface ligands (TOPO) have been investigated in comparison with the analogous nanocrystals containing electrochemically active oligoaniline ligands. The TOPO-capped nanocrystals have been studied in a wide size range (from 3 to 6.5 nm) with the goal to amplify the influence of the quantum confinement effect on the electrochemical response. The determined HOMO and LUMO levels have been found in good agreement with the ones obtained from photoluminescence studies and those predicted theoretically. Ligand exchange with aniline tetramer significantly influences the voltammetric peaks associated with the HOMO oxidation and the LUMO reduction of the quantum dots, which are shifted to higher and lower potentials, respectively. These shifts are interpreted in terms of the positive ligand charging which precedes the oxidation of the nanocrystals and the insulating nature of the ligand in the case of the nanocrystal reduction. The ligand-nanocrystal interactions have also been studied by UV-Vis-NIR and Raman spectroelectrochemistry in comparison with a specially prepared model compound which, apart from the anchoring function is identical to the grafted oligoaniline ligand. Both spectroelectrochemical techniques clearly indicate the same nature of the oxidation/reduction pathway for both the model compound and the grafted ligand. The influence of the grafting is manifested by a shift in the onset of the ligand oxidation as compared to the case of the "free" model compound. Since both components (ligands and nanocrystals) mutually influence their electrochemical and spectroelectrochemical properties, the newly developed system can be considered as a true molecular hybrid. Such hybrids are of interest because the potential zone of the ligand electroactivity is well separated from that of the nanocrystals and, as a result, the organic part can be electrochemically switched between the semiconducting and the conducting states with no change in the oxidation state of the nanocrystal. The newly developed system offers therefore the possibility of an electrical addressing of individual nanocrystals via the conducting ligands.

No abstract