No abstract

Biophenols have attracted increasing attention during the past few years due to their biological activities and natural abundance and are potential targets for the food and pharmaceutical industries. Olive mill waste (OMW) is rich in biophenols and typically contains 98% of the total phenols in the olive fruit, making value addition to OMW an attractive enterprise. The phenolic profile of OMW is complex, yet this complexity has not been fully exploited in the valorization of the waste. Most work on the bioactivity of OMW has focused on antioxidant and antimicrobial activities. The analytical techniques used to identify and quantify active biophenols are also reviewed. Keywords: Olive mill waste; biophenols; bioactivity; analysis; value addition; antioxidant; antimicrobial

Olive mill waste is a potential source for the recovery of phytochemicals with a wide array of biological activities. Phytochemical screening of hexane, methanol, and water extracts revealed a diversity of compounds, perhaps overlooked in previous studies through intensive cleanup procedures. Methanol and water extracts contained large amounts of biophenols, and further testing of polar extraction solvents, including ethyl acetate, ethanol, propanol, acetone, acetonitrile, and water/methanol mixtures, highlighted the latter as the solvent of choice for extraction of the widest array of phenolic compounds. Stabilization of the resulting extract was best achieved by addition of 2% (w/w) sodium metabisulfite. Quantitative data are reported for nine biophenols extracted using 60% (v/v) methanol in water with 2% (w/w) sodium metabisulfite. Six compounds had recoveries of greater than 1 g/kg of freeze-dried waste: hydroxytyrosol glucoside, hydroxytyrosol, tyrosol, verbascoside, and a derivative of oleuropein.

No abstract

This study reports an optimized headspace-solid phase microextraction (HS-SPME) method for the determination of methoxypyrazines in wine. Analysis was performed by using comprehensive two-dimensional gas chromatography with novel detection capabilities, including nitrogen phosphorus detection (GC x GC-NPD) and time-of-flight mass spectrometry (GC x GC-TOFMS). In the latter, stable isotope dilution was performed for the quantitation of 2-methoxy-3-(2-methylpropyl) pyrazine (IBMP), using labelled 2-(2H3)methoxy-3-(2-methylpropyl)pyrazine (d3-IBMP) as the internal standard, and resolution of the two analogues was facilitated using the deconvolution capabilities of the TOFMS. This research represents the first report of HS-SPME with isotope dilution and GC x GC-TOFMS (GC x GC-IDTOFMS). Analysis by GC x GC-NPD enabled detection limits of 0.5 ng/L for the quantitation of IBMP, which was superior to that obtained using GC x GC-IDTOFMS (1.95 ng/L). Nevertheless, both methods were adequately sensitive for real wine analysis, yielding highly comparable IBMP concentrations of 26.1 and 27.8 ng/L, respectively, from a Sauvignon blanc wine. The complexity of the real wine headspace was simplified as a result of selective detection using GC x GC-NPD and, in the case of GC x GC-IDTOFMS, the use of extracted ion chromatograms (EICs).

No abstract

For compound 14, the 13 C NMR δ value of 22.0 (t) should be replaced by 39.3 (t).

No abstract