A deep-etching method was used to determine inclusions in solidified direct chill cast aluminum ingots. The technique was developed to allow easy quantification of the amount and size distribution of inclusions over billet lengths and cross sections. A pressure filtration (Prefil) test also was used to verify molten alloy cleanliness during casting, and the results of these measurements then were compared. The amount and distribution of nonmetallic inclusions were analyzed, as determined using a NaOH deep-etching method over billet lengths and cross sections. A higher inclusion count was observed at both billet ends, with more inclusions located nearer the billet section centerline. Furthermore, the inclusion density in the radial direction at every distance along the billet length was distributed inhomogeneously. Differences were observed between Prefil samples taken at different casting stages. The Prefil curves and metallographic analysis of Prefil residue obtained from melt samples, at an early casting stage or before degassing, indicate more oxides than in a melt sample taken under steady-state casting conditions. A reasonable correlation was established between the number of inclusions in the molten alloy (measured using Prefil and LiMCA) and the etch pits on deep-etched surfaces of billet cross sections.

No abstract

No abstract

The vertical Bridgman directional solidification equipment has been used in several investigations to simulate direct chill casting of wrought aluminium alloys. As a basis for such investigations and alloy developments, it is important to have an understanding of the performance of the furnace used during simulation of the casting conditions. In this investigation the thermal conditions in the furnace have been analysed in detail, both by measurements and by mathematical modelling. The growth characteristics of the furnace, such as gradient, growth rates and cooling rates have been compared to conditions in large ingots. The direct chill casting conditions, which the simulations have been compared to, are casting of slabs of 330 and 600 mm thickness of an aluminium AA3003 type alloy. The results show that the experiments are able to simulate the cooling conditions in the ingots except from the surface zone. Comparisons of the microstructures have been made and a good agreement has been obtained for structure parameters such as grain size and DAS.

Inclusion distribution was studied in commercial aluminum DC-cast billets and slabs using a newly developed deep-etching method. Analyses revealed a nonuniform distribution of nonmetallic inclusions across billet diameters and lengths, and also across slab thicknesses and widths. In as-cast billets, more inclusions were found at the beginning and end of the billet length; more were present near the cross-section center than near the surface. In slabs, inclusions were located mostly within 13 mm of the surface and in a band between the centerline and the surface. Few inclusions were found 60 to 100 mm from the slab surface or at the centerline. In addition, comparing slab quality after casting using three types of ceramic foam filters (CFFs; i.e., 30 ppi, 50 ppi, and 50 ppi + HF) revealed significant differences in inclusion size, number, and distribution. Casting slabs using a finer pore-size filter (50 ppi) reduced the number of nonmetallic inclusions greatly. The inclusion distribution patterns observed in the solidified slabs are discussed in terms of melt flow during casting.