BackgroundLignin is known to hinder efficient enzymatic conversion of lignocellulose in biorefining processes. In particular, nonproductive adsorption of cellulases onto lignin is considered a key mechanism to explain how lignin retards enzymatic cellulose conversion in extended reactions.ResultsLignin-rich residues (LRRs) were prepared via extensive enzymatic cellulose degradation of corn stover (Zea mays subsp. mays L.), Miscanthus × giganteus stalks (MS) and wheat straw (Triticum aestivum L.) (WS) samples that each had been hydrothermally pretreated at three severity factors (log R0) of 3.65, 3.83 and 3.97. The LRRs had different residual carbohydrate levels—the highest in MS; the lowest in WS. The residual carbohydrate was not traceable at the surface of the LRRs particles by ATR-FTIR analysis. The chemical properties of the lignin in the LRRs varied across the three types of biomass, but monolignols composition was not affected by the severity factor. When pure cellulose was added to a mixture of LRRs and a commercial cellulolytic enzyme preparation, the rate and extent of glucose release were unaffected by the presence of LRRs regardless of biomass type and severity factor, despite adsorption of the enzymes to the LRRs. Since the surface of the LRRs particles were covered by lignin, the data suggest that the retardation of enzymatic cellulose degradation during extended reaction on lignocellulosic substrates is due to physical blockage of the access of enzymes to the cellulose caused by the gradual accumulation of lignin at the surface of the biomass particles rather than by nonproductive enzyme adsorption.ConclusionsThe study suggests that lignin from hydrothermally pretreated grass biomass retards enzymatic cellulose degradation by acting as a physical barrier blocking the access of enzymes to cellulose rather than by inducing retardation through nonproductive adsorption of enzymes.Electronic supplementary materialThe online version of this article (10.1186/s13068-018-1085-0) contains supplementary material, which is available to authorized users.

Hydrothermal liquefaction (HTL) is a promising technique for conversion of wet biomasses containing varying amounts of carbohydrate, protein, lipid, and lignin. In this work, mixtures of these model compounds were subjected to HTL at 335 °C. As many as 67 compounds were quantitated in the aqueous phase, including small organic acids, cyclic oxygenates, fatty acids, nitrogenates, and oxygenated aromatics. The concentrations correlated with the ratio of the model compounds. Principal component analysis separated samples on the basis of their quantitative results which could be linked to their biochemical composition. Concentrations of the analytes were modeled with partial least squares regression, and high-quality predictions were made from quality control (QC) samples and to varying degrees from Dried Distillers Grains with Solubles (DDGS), Miscanthus x giganteus, and Chlorella vulgaris. Values for total organic carbon (TOC), total nitrogen (TN), and pH were also predicted from QC samples, DDGS, M. x giganteus, and C. vulgaris. Carbohydrate and lipid contents mainly influenced TOC values and could be used for minimizing loss of organics, for techno-economic analysis, and for assessing potential for anaerobic digestion and thermal gasification. Pyrazines were modeled using linear, exponential, and second-degree polynomial fits, depending on whether carbohydrate or protein was the limiting biochemical component, which could be a way of controlling nitrogen and carbon displacement to the aqueous phase. This work shows that TOC, TN, pH, and concentrations of single compounds in the aqueous phase from HTL can, in many cases, be predicted from HTL of mixtures of biomass constituents.

Dimethyl sulfide (DMS) is produced by plankton in oceans and constitutes the largest natural emission of sulfur to the atmosphere. In this work, we examine new particle formation from the primary pathway of oxidation of gas-phase DMS by OH radicals. We particularly focus on particle growth and mass yield as studied experimentally under dry conditions using the atmospheric simulation chamber AURA. Experimentally, we show that aerosol mass yields from oxidation of 50–200 ppb of DMS are low (2–7%) and that particle growth rates (8.2–24.4 nm/h) are comparable with ambient observations. An HR-ToF-AMS was calibrated using methanesulfonic acid (MSA) to account for fragments distributed across both the organic and sulfate fragmentation table. AMS-derived chemical compositions revealed that MSA was always more dominant than sulfate in the secondary aerosols formed. Modeling using the Aerosol Dynamics, gas- and particle-phase chemistry kinetic multilayer model for laboratory CHAMber studies (ADCHAM) indicates that the Master Chemical Mechanism gas-phase chemistry alone underestimates experimentally observed particle formation and that DMS multiphase and autoxidation chemistry is needed to explain observations. Based on quantum chemical calculations, we conclude that particle formation from DMS oxidation in the ambient atmosphere will most likely be driven by mixed sulfuric acid/MSA clusters clustering with both amines and ammonia.

The selectivity of photocatalytic phenol production from the direct oxidation of benzene can be enhanced by fine adjustment of the morphology and composition of Au-Pd metal nanoparticles supported on titanium dioxide thereby suppressing the decomposition of benzene and evolution of phenolic compounds.

No abstract

Hydrothermal liquefaction is a promising technique for the production of bio-oil. The process produces an oil phase, a gas phase, a solid residue, and an aqueous phase. Gas chromatography coupled with mass spectrometry is used to analyze the complex aqueous phase. Especially small organic acids and nitrogen-containing compounds are of interest. The efficient derivatization reagent methyl chloroformate was used to make analysis of the complex aqueous phase from hydrothermal liquefaction of dried distillers grains with solubles possible. A circumscribed central composite design was used to optimize the responses of both derivatized and nonderivatized analytes, which included small organic acids, pyrazines, phenol, and cyclic ketones. Response surface methodology was used to visualize significant factors and identify optimized derivatization conditions (volumes of methyl chloroformate, NaOH solution, methanol, and pyridine). Twenty-nine analytes of small organic acids, pyrazines, phenol, and cyclic ketones were quantified. An additional three analytes were pseudoquantified with use of standards with similar mass spectra. Calibration curves with high correlation coefficients were obtained, in most cases R (2) > 0.991. Method validation was evaluated with repeatability, and spike recoveries of all 29 analytes were obtained. The 32 analytes were quantified in samples from the commissioning of a continuous flow reactor and in samples from recirculation experiments involving the aqueous phase. The results indicated when the steady-state condition of the flow reactor was obtained and the effects of recirculation. The validated method will be especially useful for investigations of the effect of small organic acids on the hydrothermal liquefaction process.

When citing, please refer to the published version.

Finding sustainable and commercially viable sources of occlusive materials, as an alternative to petroleum, is of great interest. Inspired by the fundamental role of long chain fatty acids in maintaining skin barrier, ultralong fatty acyl derivatives with diverse structures (varied acyl chain length and different polar head; i.e. glycerol, ethylene glycol, and diethylene glycol) were synthesized. These molecules can be feasibly obtained via enzymatic esterification of fatty acids or fractionated from commercial glycerides mixture via short path distillation. The molecular packing behaviors of compounds were characterized via differential scanning calorimetry, Fourier transform infrared, and Langmuir isotherm measurements. The structure–property relationship study reveals that a glycerol molecule monoacylated with an ultralong fatty acyl is the derivative which entails the most occlusive properties of the series of ultralong chain fatty acid derivatives. Fast Fourier transform filtering (FFTF) analysis of atomic force microscopy images verified a homogeneous monolayer packing of glyceryl monobehenate monolayer, and the water vapor transmission study demonstrated that the formulation of glyceryl monobehenate at 3% w/w in a phospholipid-containing emulsion generates an occlusive film significantly superior to a 3% w/w petrolatum formulation. This work demonstrated that natural glyceryl monobehenate can be a novel source of sustainable occlusive structuring agents and green replacements for petrolatum.