A series of second-generation dendronized wedge polymers were synthesized by ring-opening metathesis polymerization, and the linear viscoelastic response over a wide range of temperatures was investigated. From 0 to 90 °C the dynamic moduli (G′(ω) and G″(ω)) were determined, and frequency−temperature superposition was used to create master curves that showed behavior from the terminal zone to the glassy regime. An apparent extremely low rubbery plateau of ∼10 kPa was observed in both the dynamic response and in the corresponding van Gurp−Palmen plot. However, further investigation shows that the apparent rubbery plateau is related to the steady-state recoverable compliance, not the onset of entanglements. In addition, these wedge polymers exhibit an extremely low glassy modulus of ∼100 MPa at 0 °C, which is shown to increase at 1 Hz to ∼700 MPa at −80 °C for the wedge polymer 2G-EHW-311. In addition, both small-and wide-angle X-ray scattering patterns were obtained for all of the polymers investigated, and these showed that the polymer molecules adopt an extended cylinder conformation. Furthermore, based on calorimetric measurements, the polymers were found to exhibit two glass transition temperatures, with a 100 K difference between the higher (T g,hi = 26.8 ± 0.7 °C) and lower glass transition temperatures (T g,lo = −76.1 ± 1.1 °C) for the 2G-EHW-311 material. Hence, an intermediate regime extends to well below the T g,hi to T g,lo , providing an explanation for the low glassy modulus of ∼100 MPa at 0 °C and its increase to ∼700 MPa when measured at T g,hi − 100 °C and approaching the T g,lo .

Thermoplastic polymer fiber-thermoplastic polymer matrix composites (PPCs or PRFPs), often recognized as self-reinforced or single polymer composites, are potential candidates for future advanced polymer composites because of various advantages (e.g., recyclability, formability, low-cost, ultra-lightweight, environmental friendliness, etc.). The manufacturability and mechanical behavior of these composites compared to conventional carbon-/glass-/aramid-fiberreinforced polymers is of great interest to the composites community, but there are a limited number of studies in this area. To this end, this paper reviewed fabrication methods with different processing parameters and mechanical behavior of uni-/multi-directional thermoplastic PPCs featuring continuous thermoplastic Lisa D. Fring and Madhusudhan R. Pallak contributed equally to this study.

No abstract

The glass transition behavior of polystyrene as a function of different cooling rates with scanning to two different end temperatures, 30 C and À80 C, was investigated for four different substrate conditions using Flash differential scanning calorimetry, a fast scanning nanocalorimetry technique. In addition, structural recovery of polystyrene was performed at 20 C for aging times from 0.01 s to 8 h with scanning to À80 C for the same samples. A broad endotherm appears to grow at low temperatures (T << T g ) as cooling rate decreases and aging time increases, which is influenced by the substrate underlying the film, as well as by the end temperature condition in the scanning experiment. On

No abstract