The structural and thermal properties of human tooth enamel, dentine and three synthetic hydroxyapatite samples with Ca/P ratios of 1.57 (Ca deficiency), 1.67 and 1.77 (Ca excess), respectively, were analysed in the temperature range from 20 to 600 °C to have information on the parameters involved in the ionic/electrical conductivities reported for human tooth enamel between 200 and 350 °C approximately. Studies were carried out through x-ray diffraction, thermo-gravimetric analysis, differential scanning calorimetry, Fourier transform infrared spectroscopy and temperature programmed desorption. Chemical analysis was performed by x-ray characteristic energy dispersive spectroscopy. Results indicate a strong correlation between the removal of the OH− groups from the hydroxyapatite unit cell and the expulsion of absorbed water and lattice water registered during heating.

The obtention of hydroxyapatite (HAp) is reported using brushite (CaHPO4.2H2O) and the skeleton of a starfish (Mellita eduardobarrosoi sp. nov.), primarily composed of magnesian calcite ((Ca,Mg)CO3) as precursors. Stoichiometric amounts of both were reacted under hydrothermal conditions: a pressure of 5.8 MPa and a temperature of 200 degrees C for 2, 4, 6, 8, 10, and 20 h of reaction times. The samples obtained were characterized by means of scanning electron microscopy, X-ray diffraction, infrared spectroscopy, and transmission electron microscopy. Two defined populations of HAp fibers were found: A bundle of fibers 75 mum in length and 1-13 mum in diameter, and a second bundle of fibers 5 mum in length and less than 0.5 mum in diameter. Furthermore, an increase in HAp formation and a Ca/P ratio as a function of reaction time were observed. The growth mechanism of HAp is also discussed.