Solar PV power generation has achieved rapid growth in developing countries which has many merits such as absence of noise, longer life, no pollution, less time for installation, and ease of grid interface. A maximum power point tracking circuit (MPPT) consists of DC-DC power electronics converters that are used to improve the energy attainment from solar PV array. This paper presents a detailed analysis to control of chaos, a non-linear dynamic in SEPIC DC-DC converter interfaced solar PV system, to minimize the oscillations near to MPP. In SEPIC DC-DC converter, the input inductor current is continuous and capable of sweeping the whole I-V curve of a PV module from open circuit voltage (Voc) to short circuit current (Isc) operating points. To trace the true maximum power point and to nullify the oscillations near to MPP, the yield output voltage needs to ensure period-1 operation.
The main objective of this work is to study the behaviour of the solar PV systems and model the efficient Grid-connected solar power system. The DC-DC MPPT circuit using chaotic pulse width modulation has been designed to track maximum power from solar PV module. The conversion efficiency of the proposed MPPT system is increased when CPWM is used as a control scheme. This paper also proposes a simplified multilevel (seven level) inverter for a grid-connected photovoltaic system. The primary goal of these systems is to increase the energy injected to the grid by keeping track of the maximum power point of the panel, by reducing the switching frequency, and by providing high reliability. The maximum power has been tracked experimentally. It is compared with parallel boost converter. Also this model is based on mathematical equations and is described through an equivalent circuit including a PV source with MPPT, a diode, a series resistor, a shunt resistor, and dual boost converter with active snubber circuit. This model can extract PV power and boost by using dual boost converter with active snubber. By using this method the overall system efficiency is improved thereby reducing the switching losses and cost.
This experimental study deals with the investigation of chaos during the regulation of output voltage of solar photovoltaic module. The Cuk converter is used as an interface between solar PV module and load, since the Cuk converter is the good choice for the maximum power point tracking (MPPT) circuits. The input voltage of the converter is controlled in order to regulate the operating point of the solar PV module. This paper proposes to design PID controller to obtain the input voltage of the converter is chaotic free and regulated one. The PID controller improves the transient response on the input voltage of the converter, avoids oscillation, overshoot, making easier the functioning of MPPT methods and ensures period -1 operation.
-The main objective of this paper is to design DC-DC MPPT circuit using chaotic pulse width modulation to track maximum power from solar PV module for space application. The direct control method of tracking is used to extract maximum power. The nominal duty cycle of the main switch of DC-DC SEPIC converter is adjusted so that the solar panel output impedance is equal to the input resistance of the SEPIC converter which results better spectral performance in the tracked voltages when compared to conventional PWM control. The conversion efficiency of the proposed MPPT system is increased when CPWM is used as a control scheme
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.