[1] The Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) is a hyperspectral imager on the Mars Reconnaissance Orbiter (MRO) spacecraft. CRISM consists of three subassemblies, a gimbaled Optical Sensor Unit (OSU), a Data Processing Unit (DPU), and the Gimbal Motor Electronics (GME). CRISM's objectives are (1) to map the entire surface using a subset of bands to characterize crustal mineralogy, (2) to map the mineralogy of key areas at high spectral and spatial resolution, and (3) to measure spatial and seasonal variations in the atmosphere. These objectives are addressed using three major types of observations. In multispectral mapping mode, with the OSU pointed at planet nadir, data are collected at a subset of 72 wavelengths covering key mineralogic absorptions and binned to pixel footprints of 100 or 200 m/pixel. Nearly the entire planet can be mapped in this fashion. In targeted mode the OSU is scanned to remove most along-track motion, and a region of interest is mapped at full spatial and spectral resolution (15-19 m/pixel, 362-3920 nm at 6.55 nm/channel). Ten additional abbreviated, spatially binned images are taken before and after the main image, providing an emission phase function (EPF) of the site for atmospheric study and correction of surface spectra for atmospheric effects. In atmospheric mode, only the EPF is acquired. Global grids of the resulting lower data volume observations are taken repeatedly throughout the Martian year to measure seasonal variations in atmospheric properties. Raw, calibrated, and map-projected data are delivered to the community with a spectral library to aid in interpretation.

Phyllosilicates, a class of hydrous mineral first definitively identified on Mars by the OMEGA (Observatoire pour la Mineralogie, L'Eau, les Glaces et l'Activitié) instrument 1,2 , preserve a record of the interaction of water with rocks on Mars. Global mapping showed that phyllosilicates are widespread but are apparently restricted to ancient terrains and a relatively narrow range of mineralogy (Fe/Mg and Al smectite clays). This was interpreted to indicate that phyllosilicate formation occurred during the Noachian (the earliest geological era of Mars), and that the conditions necessary for phyllosilicate formation (moderate to high pH and high water activity 3 ) were specific to surface environments during the earliest era of Mars's history 4 . Here we report results from the Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) 5 of phyllosilicate-rich regions. We expand the diversity of phyllosilicate mineralogy with the identification of kaolinite, chlorite and illite or muscovite, and a new class of hydrated silicate (hydrated silica). We observe diverse Fe/Mg-OH phyllosilicates and find that smectites such as nontronite and saponite are the most common, but chlorites are also present in some locations. Stratigraphic relationships in the Nili Fossae region show olivine-rich materials overlying phyllosilicate-bearing units, indicating the cessation of aqueous alteration before emplacement of the olivine-bearing unit. Hundreds of detections of Fe/Mg phyllosilicate in rims, ejecta and central peaks of craters in the southern highland Noachian cratered terrain indicate excavation of altered crust from depth. We also find phyllosilicate in sedimentary deposits clearly laid by water. These results point to a rich diversity of Noachian environments conducive to habitability.High-spatial-resolution, precision-pointing and nested observations of CRISM 5 , the Context Imager (CTX) 6 , and the High Resolution Imaging Science Experiment (HiRISE) 7 instruments on the Mars Reconnaissance Orbiter (MRO) resolve mineralogical, stratigraphic and geological relationships for phyllosilicate deposits. This combination of instruments permits mineralogical mapping at 18 m per pixel with CRISM linked with metre-scale geomorphology from CTX and HiRISE. We focus here on the stratigraphic setting of phyllosilicate-bearing rocks in three regions and report the detection of phyllosilicate in sedimentary settings.We identify two principal classes of mineral in the CRISM data on the basis of observed absorptions: Al phyllosilicates and the more common and spatially dominant Fe/Mg phyllosilicates. The increased spatial and spectral resolutions of CRISM have revealed a diversity of absorption band shapes, positions and combinations indicating variations in phyllosilicate type and composition ( Fig. 1; see Methods for processing and identification details). Most spectra show a band at ,1.4 mm from the overtone of the OH stretch, a strong 1.9-mm H 2 O band and absorptions near 2.28-2.30 mm (for example, spectrum 3 in Fig. 1b), which ...

CRISM (Compact Reconnaissance Imaging Spectrometer for Mars) is a hyperspectral imager that will be launched on the MRO (Mars Reconnaissance Orbiter) spacecraft in August 2005. MRO's objectives are to recover climate science originally to have been conducted on the Mars Climate Orbiter (MCO), to identify and characterize sites of possible aqueous activity to which future landed missions may be sent, and to characterize the composition, geology, and stratigraphy of Martian surface deposits. MRO will operate from a sun-synchronous, near-circular (255x320 km altitude), near-polar orbit with a mean local solar time of 3 PM.CRISM's spectral range spans the ultraviolet (UV) to the mid-wave infrared (MWIR), 383 nm to 3960 nm. The instrument utilizes a Ritchey-Chretien telescope with a 2.12° field-of-view (FOV) to focus light on the entrance slit of a dual spectrometer. Within the spectrometer, light is split by a dichroic into VNIR (visible-near-infrared, 383-1071 nm) and IR (infrared, 988-3960 nm) beams. Each beam is directed into a separate modified Offner spectrometer that focuses a spectrally dispersed image of the slit onto a two dimensional focal plane (FP). The IR FP is a 640 x 480 HgCdTe area array; the VNIR FP is a 640 x 480 silicon photodiode area array. The spectral image is contiguously sampled with a 6.6 nm spectral spacing and an instantaneous field of view of 61.5 µradians. The Optical Sensor Unit (OSU) can be gimbaled to take out along-track smear, allowing long integration times that afford high signal-to-noise ratio (SNR) at high spectral and spatial resolution. The scan motor and encoder are controlled by a separately housed Gimbal Motor Electronics (GME) unit. A Data Processing Unit (DPU) provides power, command and control, and data editing and compression.CRISM acquires three major types of observations of the Martian surface and atmosphere. In Multispectral Mapping Mode, with the gimbal pointed a planet nadir, data are collected at frame rates of 15 or 30 Hz. A commandable subset of wavelengths is saved by the DPU and binned 5:1 or 10:1 cross-track. The combination of frame rates and binning yields pixel footprints of 100 or 200 m. In this mode, nearly the entire planet can be mapped at wavelengths of key mineralogic absorption bands to select regions of interest. In Targeted Mode, the gimbal is scanned over ±60°f rom nadir to remove most along-track motion, and a region of interest is mapped at full spatial and spectral resolution. Ten additional abbreviated, pixel-binned observations are taken before and after the main hyperspectral image at longer atmospheric path lengths, providing an emission phase function (EPF) of the site for atmospheric study and correction of surface spectra for atmospheric effects. In Atmospheric Mode, the central observation is eliminated and only the EPF is acquired. Global grids of the resulting lower data volume observation are taken repeatedly throughout the Martian year to measure seasonal variations in atmospheric properties.

[1] Surface temperatures derived from thermal infrared measurements provide a means of understanding the physical properties of the lunar surface. The contrasting thermophysical properties between rocks and regolith fines cause multiple temperatures to be present within the field of view of nighttime multispectral data returned from the Lunar Reconnaissance Orbiter (LRO) Diviner Radiometer between 60°N/S latitudes. Regolith temperatures are influenced by the presence of rocks in addition to factors such as the thermophysical properties of the regolith fines, latitude and local slopes, and radiative heating from adjacent crater walls. Preliminary comparisons of derived rock concentrations with LRO Camera images show both qualitative and quantitative agreement. Although comparisons of derived rock concentrations with circular polarization ratio radar data sets display general similarities, there are clear differences between the two data sets in the relative magnitude and areal extent of rocky signatures. Several surface units can be distinguished based on their regolith temperature and rock concentration values and distributions including maria and highlands surfaces, rocky impact craters, rilles, and wrinkle ridges, dark mantled deposits, and isolated cold surfaces. Rock concentrations are correlated with crater age and rocks are only preserved on the youngest surfaces or where steep slopes occur and mass wasting prevents mantling with fines. The presence of rocky surfaces excavated by young impacts allows for the estimation of minimum regolith thickness from the size of the impact. The derived rock concentrations confirm the presence of thicker regolith cover in the highlands and in locations of radar-dark haloes.

[1] Orbital images from the MESSENGER spacecraft show that~27% of Mercury's surface is covered by smooth plains, the majority (>65%) of which are interpreted to be volcanic in origin. Most smooth plains share the spectral characteristics of Mercury's northern smooth plains, suggesting they also share their magnesian alkali-basalt-like composition. A smaller fraction of smooth plains interpreted to be volcanic in nature have a lower reflectance and shallower spectral slope, suggesting more ultramafic compositions, an inference that implies high temperatures and high degrees of partial melting in magma source regions persisted through most of the duration of smooth plains formation. The knobby and hummocky plains surrounding the Caloris basin, known as Odin-type plains, occupy an additional 2% of Mercury's surface. The morphology of these plains and their color and stratigraphic relationships suggest that they formed as Caloris ejecta, although such an origin is in conflict with a straightforward interpretation of crater size-frequency distributions. If some fraction is volcanic, this added area would substantially increase the abundance of relatively young effusive deposits inferred to have more mafic compositions. Smooth plains are widespread on Mercury, but they are more heavily concentrated in the north and in the hemisphere surrounding Caloris. No simple relationship between plains distribution and crustal thickness or radioactive element distribution is observed. A likely volcanic origin for some older terrain on Mercury suggests that the uneven distribution of smooth plains may indicate differences in the emplacement age of large-scale volcanic deposits rather than differences in crustal formational process.

No abstract

The WAC is a 7-color push-frame camera (100 and 400 m/pixel visible and UV, respectively), while the two NACs are monochrome narrow-angle linescan imagers (0.5 m/pixel). The primary mission of LRO is to obtain measurements of the Moon that will enable future lunar human exploration. The overarching goals of the LROC investigation include landing site identification and certification, mapping of permanently polar shadowed and sunlit regions, meter-scale mapping of polar regions, global multispectral imaging, a global morphology base map, characterization of regolith properties, and determination of current impact hazards.

No abstract