A magnetic tunnel transistor (MTT) device using an amorphous n-type Si semiconductor film for the base and collector consisting of [CoFe/NiFe] (free layer) and Si (top layer) multilayers is used to study the spin-dependent hot electron magnetocurrent (MC) and the tunneling magnetoresistance at room temperature. A large MC of more than 40.2 % is observed at the emitter -base bias voltage V BE of 0.62 V. The increasing emitter hot current and transfer ratio with the increase of the emitter -base voltage are due mainly to a rapid creation of a number of conduction-band states in the Si collector. However, above a V BE of 0.62 V, a rapid decrease of the MC is observed in an amorphous Si-based MTT. IntroductionThe most concerned interest in the spin electronics research field is the performance of magnetic random access memories (MRAMs) and logic magnetic tunnel transistors (MTTs) considered under the same conditions of charge and spin degree of freedom [1 -3]. The magnetic tunnel junction (MTJ)-type MTT device developed by the S. S. P. Parkin research group has the emitter as a pinned layer of the MTJ, the base as a free CoFe layer, and the collector as an n-type GaAs substrate using the energy difference of the injected hot electrons according to the emitter-base voltage (V EB ). On the other hand, the structure of a spin-valve-type MTT device has the emitter as a Cu or Au layer and the base as a spin valve. For the two types of MTTs, the attenuation length (λ maj ) of hot electrons arriving at the base is 60 -90 Å, corresponding to V EB = 1.0 -1.8 V. It was reported [1 -3] that the transfer ratio (collector current: I C /emitter current: I E ) going through the base is maintained at about 10 -4 [4,5]. Also, up to a thick base layer of 120 Å, a magnetocurrent (MC) depending on an external magnetic field has maximum and minimum values, corresponding to magnetization arrayed parallel and antiparallel, changing from 65% to 1250% at 71 K [6,7]. From these results, the development of MTT devices is an ongoing issue. However, MTTs with a Si or GaAs substrate contain several hurdles such as the leakage current through a wide collector electrode, the formation of a silicide layer, and the impurity at the interface. This paper introduces the fabrication of a new MTT structure and reports the characteristics of it using a collector of an n-type Si amorphous thin film as the top layer.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.