Sandwich composite structures are comprised of a low-density core (commonly honeycomb) and facesheets. They are typically used in applications that require lightweight for efficient design, such as in the marine and aerospace industries. This work investigates the feasibility of adopting triply periodic minimal surface (TPMS) cellular structures as the core for sandwich composites. Sandwich structures were manufactured using a carbon fiber-reinforced polymer (CFRP) facesheet and three different 304 L stainless steel core structures (honeycomb, gyroid TPMS, and diamond TPMS). Three mechanical tests, namely edgewise compression, three-point bend, and impact test, were carried out to evaluate the performance of each sandwich configuration. The experimental results of the non-traditional sandwich configurations were compared against those of a honeycomb core sandwich composite. The edgewise compression test showed that the ultimate edgewise compressive strength increased by 7% when the honeycomb core was replaced by the gyroid core and reduced by 2% when the diamond core replaced the honeycomb core. The three-point bend test showed that the traditional honeycomb core sandwich configuration had a higher shear yield stress when compared to the non-traditional sandwich structures. The shear yield stress was reduced by 54% when non-traditional sandwich cores were used. The shear ultimate stress was reduced by 41% and 37% when the honeycomb core was replaced by the gyroid and diamond structure, respectively. Impact test results, on the other hand, showed that the peak force recorded during the impact event was reduced, while the absorbed energy was increased when non-traditional cores were used. Peak force was reduced by 28% and 39%, while the absorbed energy was increased by 9% and 16% when the honeycomb core was replaced by the gyroid and diamond cores, respectively.
Modern aerostructures, including wings and fuselages, increasingly feature sandwich structures due to their high‐energy absorption, low weight, and high flexural stiffness. The face sheet of these sandwich structures are typically thin composite laminates with interior honeycombs made of Nomex or aluminum. Standard cores are structurally efficient, but their design cannot be varied throughout the structure. With additive manufacturing (AM) technology, these core geometries can be altered to meet the design requirements that are not met in standard honeycomb cores. This study used a modified aluminum honeycomb core, with increased surface area on the top and bottom, as the core material in sandwich panels. The modified honeycomb core was produced through the laser powder bed fusion method. The behavior of the modified sandwich composite panels was evaluated through three‐point bend, edgewise compression, and impact tests, and their performance was compared to that of a conventional honeycomb core sandwich panel. The three‐point bend test results indicated that the sandwich structure's ultimate shear strength improved by 12.6% with the modified honeycomb core. Additionally, the displacement at the failure of the structure increased by 11%. The edgewise compression tests showed that the ultimate edgewise compressive strength improved by 19.1% when using the modified core. The impact test results revealed that the peak force increased by 8% and the energy‐absorbing capacity of the sandwich structure increased by 20% with the use of the modified honeycomb core.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.