Nanogels are water-soluble crosslinked polymer networks with tremendous potential in targeted imaging and controlled drug and gene delivery.

Controlled degradability in response to the local environment is one of the most effective strategies to achieve spatiotemporal release of genes from a polymeric carrier. Exploiting the differences in reduction potential between the extracellular and intracellular environment, disulfides are frequently incorporated into the backbone of polymeric drug delivery agents to ensure efficient intracellular release of the payload. However, although to a lesser extent, reduction of disulfides may also occur in the extracellular environment and should be prevented to avoid premature release. Accurate control over the stability of disulfide linkages enables the optimization of polymeric carriers for efficient drug delivery. Bioreducible poly(amido amine)s (PAAs) with varying degrees of steric hindrance adjacent to the disulfide bonds (0, 2 or 4 methyl groups) were prepared in order to obtain carriers with controlled stability. The degradation behavior of these PAA-polymers was evaluated under different reducing conditions and their in vitro toxicities and transfection efficiencies were assessed. Degradation of the PAA-based polyplexes consistently required higher reducing strengths as the steric hindrance near the disulfide bonds increased. Polyplexes based on 2-methyl cystamine disulfide based PAA polymer (PAA) remained stable under extracellular glutathione concentrations (0.001-0.01mM), while degrading within 1h under reducing conditions similar to those in the intracellular environment (1-10mM glutathione). This polymer exhibited excellent transfection capabilities, with efficiencies up to 90% of transfected cells. PAA showed slightly reduced transfection properties compared to PAA, likely due to premature degradation. The severely hindered PAA, however, displayed increased toxicity, accompanied by reduced transfection efficiency, as a result of its exceptional stability. These results demonstrate the feasibility of introducing steric hindrance near the disulfide moiety to tune polyplex stability against bioreduction, and show that PAA is a promising polymer to be further developed for gene therapy.

Naturally occurring oligoamines, such as spermine, spermidine, and putrescine, are well-known regulators of gene expression. These oligoamines frequently have short alkyl spacers with varying lengths between the amines. Linear polyethylenimine (PEI) is a polyamine that has been widely applied as a gene vector, with various formulations currently in clinical trials. In order to emulate natural oligoamine gene regulators, linear random copolymers containing both PEI and polypropylenimine (PPI) repeat units were designed as novel gene delivery agents. In general, statistical copolymerization of 2-oxazolines and 2-oxazines leads to the formation of gradient copolymers. In this study, however, we describe for the first time the synthesis of near-ideal random 2-oxazoline/2-oxazine copolymers through careful tuning of the monomer structures and reactivity as well as polymerization conditions. These copolymers were then transformed into near-random PEI–PPI copolymers by controlled side-chain hydrolysis. The prepared PEI–PPI copolymers formed stable polyplexes with GFP-encoding plasmid DNA, as validated by dynamic light scattering. Furthermore, the cytotoxicity and transfection efficiency of polyplexes were evaluated in C2C12 mouse myoblasts. While the polymer chain length did not significantly increase the toxicity, a higher PPI content was associated with increased toxicity and also lowered the amount of polymers needed to achieve efficient transfection. The transfection efficiency was significantly influenced by the degree of polymerization of PEI–PPI, whereby longer polymers resulted in more transfected cells. Copolymers with 60% or lower PPI content exhibited a good balance between high plasmid–DNA transfection efficiency and low toxicity. Interestingly, these novel PEI–PPI copolymers revealed exceptional serum tolerance, whereby transfection efficiencies of up to 53% of transfected cells were achieved even under 50% serum conditions. These copolymers, especially PEI–PPI with DP500 and a 1:1 PEI/PPI ratio, were identified as promising transfection agents for plasmid DNA.

No abstract

Bioreducible, cationic linear poly(amino ether)s (PAEs) were designed as promising gene vectors. These polymers were synthesized by the reaction of a disulfide-functional monomer, N , N ′-dimethylcystamine (DMC), and several different diglycidyl ethers. The resulting PAEs displayed a substantial buffer capacity (up to 64%) in the endosomal acidification region of pH 7.4–5.1. The PAEs condense plasmid DNA into 80–200 nm sized polyplexes, and have surface charges ranging from +20 to +40 mV. The polyplexes readily release DNA upon exposure to reducing conditions (2.5 mM DTT) due to the cleavage of the disulfide groups that is present in the main chain of the polymers, as was demonstrated by agarose gel electrophoresis. Upon exposing COS-7 cells to polyplexes that were prepared at polymer/DNA w / w ratios below 48, cell viabilities between 80–100% were observed, even under serum-free conditions. These polyplexes show comparable or higher transfection efficiencies (up to 38%) compared to 25 kDa branched polyethylenimine (PEI) polyplexes (12% under serum-free conditions). Moreover, the PAE-based polyplexes yield transfection efficiencies as high as 32% in serum-containing medium, which makes these polymers interesting for gene delivery applications.