In this research work an attempt was made to reinforce AA7075 composites with B4C and SiC particles through stir casting route. SEM with EDS mapping revealed that the reinforcement were uniformly over the composites and hardness reduces with the addition of SiC particles owing to the inverse hall petch effect. The results revealed that wear rate reduces with addition of SiC particles owing to the formation of mechanically mixed layer and protective oxide layer confirmed through SEM with EDAX mapping. Three distinct cracks were formed, when slides at different temperature as confirmed through worn surface morphology, pits cracks and plasticization of material were the other features observed. The used motor oil properties were analyzed and results divulged that the oil suitable for dielectric fluid. Increase in Material Removal Rate (MRR), reduction in Tool Wear Ratio (TWR) and Surface Roughness (Ra) was observed with the incorporation of powder particles owing to the bridging effect. Black spots, craters, micro pits, globules and micro crack are the distinct observed on the machined surface topography. The modified Preference Ranking Organization METHod for Enrichment of Evaluations (PROMETHEE) optimization technique was utilized to find the optimal parametric combination.