The effect of potassium addition on the radial distribution of temperature and electron number density in a U-shaped direct current (dc) argon plasma operating at different arc currents has been studied by optical emission spectroscopic techniques and the power interruption method. Spatially resolved electron number densities (n e) have been determined from measured radial profiles of Balmer-Hβ spectral line. The obtained electron number densities have been used for thermodynamic temperature (T LTE) evaluation with the assumption that the arc plasma is in a state of local thermodynamic equilibrium. The excitation temperatures (T exc) have been determined from the absolute integral emissivity of the argon line at 430.01 nm. For heavy particle temperature (T h) evaluations we have used a power interruption method. The obtained results have shown that an addition of KCl decreases both electron number density and temperature of the arc column. The magnitude of such an influence on plasma parameters increases with an increase in the KCl concentration and decreases with an increase in the arc current.

No abstract

No abstract

No abstract

Spatially resolved, time-integrated optical emission spectroscopy was applied for investigation of copper plasma produced by a nanosecond infrared (IR) transversely excited atmospheric (TEA) CO2 laser, operating at 10.6 μm. The effect of surrounding air pressure, in the pressure range 0.1 to 1013 mbar, on plasma formation and its characteristics was investigated. A linear dependence of intensity threshold for plasma formation on logarithm of air pressure was found. Lowering of the air pressure reduces the extent of gas breakdown, enabling better laser-target coupling and thus increases ablation. Optimum air pressure for target plasma formation was 0.1 mbar. Under that pressure, the induced plasma consisted of two clearly distinguished and spatially separated regions. The maximum intensity of emission, with sharp and well-resolved spectral lines and negligibly low background emission, was obtained from a plasma zone 8 mm from the target surface. The estimated excitation temperature in this zone was around 7000 K. The favorable signal to background ratio obtained in this plasma region indicates possible analytical application of TEA CO2 laser produced copper plasma. Detection limits of trace elements present in the Cu sample were on the order of 10 ppm (parts per million). Time-resolved measurements of spatially selected plasma zones were used to find a correlation between the observed spatial position and time delay.