Charged Particle Monitor (CPM) on-board the AstroSat satellite is an instrument designed to detect the flux of charged particles at the satellite location. A Cesium Iodide Thallium (CsI(Tl)) crystal is used with a Kapton window to detect protons with energies greater than 1 MeV. The ground calibration of CPM was done using gamma-rays from radioactive sources and protons from particle accelerators. Based on the ground calibration results, energy deposition above 1 MeV are accepted and particle counts are recorded. It is found that CPM counts are steady and the signal for the onset and exit of South Atlantic Anomaly (SAA) region are generated in a very reliable and stable manner.

AstroSat is a multi-wavelength satellite launched on 2015 September 28. The CZT Imager of AstroSat on its very first day of operation detected a long duration gamma-ray burst (GRB) namely GRB 151006A. Using the off-axis imaging and spectral response of the instrument, we demonstrate that CZT Imager can localise this GRB correct to about a few degrees and it can provide, in conjunction with Swift, spectral parameters similar to that obtained from Fermi /GBM. Hence CZT Imager would be a useful addition to the currently operating GRB instruments (Swift and Fermi ). Specifically, we argue that the CZT Imager will be most useful for the short hard GRBs by providing localisation for those detected by Fermi and spectral information for those detected only by Swift. We also provide preliminary results on a new exciting capability of this instrument: CZT Imager is able to identify Compton scattered events thereby providing polarisation information for bright GRBs. GRB 151006A, in spite of being relatively faint, shows hints of a polarisation signal at 100-300 keV (though at a low significance level). We point out that CZT Imager should provide significant time resolved polarisation measurements for GRBs that have fluence 3 times higher than that of GRB 151006A. We estimate that the number of such bright GRBs detectable by CZT Imager is 5 -6 per year. CZT Imager can also act as a good hard X-ray monitoring device for possible electromagnetic counterparts of Gravitational Wave events.

The Cadmium Zinc Telluride Imager (CZTI) is a high energy, wide-field imaging instrument on AstroSat. CZTI's namesake Cadmium Zinc Telluride detectors cover an energy range from 20 keV to > 200 keV, with 11% energy resolution at 60 keV. The coded aperture mask attains an angular resolution of 17 over a 4• .6 × 4• .6 (FWHM) field of view. CZTI functions as an open detector above 100 keV, continuously sensitive to GRBs and other transients in about 30% of the sky. The pixellated detectors are sensitive to polarisation above ∼ 100 keV, with exciting possibilities for polarisation studies of transients and bright persistent sources. In this paper, we provide details of the complete CZTI instrument, detectors, coded aperture mask, mechanical and electronic configuration, as well as data and products.

We present the results of an analysis of the prompt gamma-ray emission from GRB 090618 using the RT -2 Experiment onboard the Coronas − P hoton satellite. GRB 090618 shows multiple peaks and a detailed study of the temporal structure as a function of energy is carried out. As the GRB was incident at an angle of 77 • to the detector axis, we have generated appropriate response functions of the detectors to derive the spectrum of this GRB. We have augmented these results using the publicly available data from the Swif t BAT detector and show that a combined spectral analysis can measure the spectral parameters quite accurately. We also attempt a spectral and timing analysis of individual peaks and find evidence for a systematic change in the pulse emission characteristics for the successive pulses. In particular, we find that the peak energy of the spectrum, E p , is found to monotonically decrease with time, for the successive pulses of this GRB.

Cadmium Zinc Telluride (CZT) detectors are high sensitivity and high resolution devices for hard X-ray imaging and spectroscopic studies. The new series of CZT detector modules (OMS40G256) manufactured by Orbotech Medical Solutions (OMS), Israel, are used in the RT-2/CZT payload onboard the CORONAS-PHOTON satellite. The CZT detectors, sensitive in the energy range of 20 keV to 150 keV, are used to image solar flares in hard X-rays. Since these modules are essentially manufactured for commercial applications, we have carried out a series of comprehensive tests on these modules so that they can be confidently used in space-borne systems. These tests lead us to select the best three pieces of the 'Gold' modules for the RT-2/CZT payload. This paper presents the characterization of CZT modules and the criteria followed for selecting the ones for the RT-2/CZT payload. The RT-2/CZT payload carries, along with three CZT modules, a high spatial resolution CMOS detector for high resolution imaging of transient X-ray events. Therefore, we discuss the characterization of the CMOS detector as well.