Direct printing of functional electronic materials may provide a new route to low-cost fabrication of integrated circuits. However, to be useful it must allow continuous manufacturing of all circuit components by successive solution deposition and printing steps in the same environment. We demonstrate direct inkjet printing of complete transistor circuits, including via-hole interconnections based on solution-processed polymer conductors, insulators, and self-organizing semiconductors. We show that the use of substrate surface energy patterning to direct the flow of water-based conducting polymer inkjet droplets enables high-resolution definition of practical channel lengths of 5 micrometers. High mobilities of 0.02 square centimeters per volt second and on-off current switching ratios of 10(5) were achieved.

Light‐emitting polymers have been studied intensively as materials for light‐emitting diodes (LEDs). Here research efforts toward developing these materials for commercial applications are reviewed. The Figure shows the preferred two‐layer device structure for commercial polymer LEDs as well as polyfluorene, one of the polymers discussed.

A method is demonstrated by which liquid-crystalline self-organization in rigid-rod nematic conjugated polymers can be used to control the microstructure of the active semiconducting layer in solution-processed polymer thin-film transistors (TFTs). Enhanced charge carrier mobilities of 0.01–0.02 cm2/V s and good operating stability have been achieved in polyfluorene copolymer TFTs by preparing the polymer in a nematic glassy state and by aligning the polymer chains parallel to the transport direction with the help of an alignment layer. Mobility anisotropies of 5–8 for current flow parallel and perpendicular to the alignment direction have been observed that are of the same order of magnitude as optical dichroic ratios.

We report on the physical characterization of a dioctyl‐substituted polyfluorene, both in solution and in the solid state. We focus on studies of chain geometry both by molecular modeling and by gel permeation chromatography coupled with light scattering. We determine experimentally a Kuhn segment length, lk = 17.1 ± 2.1 nm and a characteristic ratio C∞ = 21.5 %plusmn; 4.3 indicative of a stiff polymer chain. The effects on absorption and emission spectra of intermolecular interactions that lead to gelation or precipitation from solution are reported. We discuss these results in the context of the strong current interest in the nature of aggregation phenomena and their role in controlling the emissive properties of conjugated polymers. We further show that a markedly enhanced dichroism can be achieved through suitable control of the polymer microstructure.

Electroluminescence and liquid crystallinity: these are the properties of a new spacerless conjugated main‐chain liquid‐crystalline (LC) polymer reported here. The thermal and spectroscopic properties of the new glass‐forming poly‐fluorene with octyl side chains (see Figure) are described, showing that polarized electroluminescent multilayer devices should be possible.