No abstract

No abstract

No abstract

a b s t r a c tA comparative evaluation of single-stage and two-stage anaerobic digestion processes for biomethane and biohydrogen production using thin stillage was performed to assess the impact of separating the acidogenic and methanogenic stages on anaerobic digestion. Thin stillage, the main by-product from ethanol production, was characterized by high total chemical oxygen demand (TCOD) of 122 g/L and total volatile fatty acids (TVFAs) of 12 g/L. A maximum methane yield of 0.33 L CH 4 /gCOD added (STP) was achieved in the two-stage process while a single-stage process achieved a maximum yield of only 0.26 L CH 4 /gCO-D added (STP). The separation of acidification stage increased the TVFAs to TCOD ratio from 10% in the raw thin stillage to 54% due to the conversion of carbohydrates into hydrogen and VFAs. Comparison of the two processes based on energy outcome revealed that an increase of 18.5% in the total energy yield was achieved using two-stage anaerobic digestion.

Helical piles are increasingly used to support and rehabilitate structures subjected to both tensile and compressive axial loads. This paper presents a detailed investigation into the axial performance of helical piles. The study encompasses 19 full-scale load tests in different soils and numerical modeling using finite element analysis. The ultimate load criteria and load transfer mechanisms for helical piles were examined. In addition, the relationship between the installation effort (torque) and pile capacity was explored to determine its suitability for predicting pile capacity. The piles tested were made of three circular pitched bearing plates welded at a spacing of three helical diameters to a solid-square, slender steel shaft. It is proposed to determine the ultimate pile capacity as the load corresponding to pile head movement equal to 8% of the largest helix diameter plus the pile elastic deflection. A torque correlation factor, KT = 33 m–1 for compression and KT = 24 m–1 for uplift, was established to relate the ultimate pile capacity to the installation torque. It was found that load transfer to the soil is predominantly through a cylindrical shear failure surface that follows the tapered profile of the interhelices soils and the bearing capacity of the lead helix in the direction of loading.

No abstract

No abstract

No abstract