New seismic and well data in the deep-water basins of Campos, Santos, South Kwanza and Benguela, supported by plate reconstructions, help answer fundamental questions on the rifting history of the central South Atlantic, specifically on the amount and effect of fault-related deformation, and on when and where sea-floor spreading started. The Paraná mantle plume played a fundamental role -dynamically raising the plate, prolonging continental rifting by heat-softening the crust and, after break-up, delaying the onset of marine conditions. Previous discrepancies in extension and subsidence have been solved, and the location and age of the continent-ocean boundary can now be determined. Rifting involved approximately 450 km of homogeneous pure shear, equivalent to a b factor (lithosphere stretching factor) of 4.5. Break-up occurred at 123 Ma (Barremian-Aptian boundary), 7-8 Ma later than the southern South Atlantic but 6 Ma before widespread salt deposition. The mid-Atlantic ridge was initially subaerial, marked by a volcanic high. Sea-floor spreading was at a rate of 24 mm year 21 , similar to syn-rift deformation prior to breakup. Transcontinental strike-slip shear zones are not evident but a major NW-SE lithospheric lineament associated with a failed triple junction arm had a major influence on the magmatic history, both prior to and after break-up.

Numerical, thermal and rheological modelling techniques are applied to unravel the basin-forming processes and the heat flow and burial history of the Rheno-Hercynian fold belt (Rhenish Massif), the adjacent Subvariscan foreland (Ruhr Basin), and the intramontane Saar Nahe Basin. Thermal history and crustal architecture in the study areas were affected mainly by the Variscan Orogeny during late Palaeozoic times. Calibration of the simulated thermal histories is primarily based on vitrinite reflectance and fission-track data. Mechanical modelling reveals average/~ values of 1.7, reaching a maximum of 2.4 in the central basin (Mosel Graben) and at the transition to the Giessen Ocean to the south during Early Devonian rifting. This stage was associated with tholeitic magmatism and an elevated heat flow of up to 110 mW m -2, preserved in weakly overprinted syn-rift sediments. Average basal heat flow during maximum burial at the end of the Carboniferous period (i.e. the end of crustal shortening) was between 50 and 70 mW m -2 with a slight decrease from the Subvariscan foreland basins towards the Rheno-Hercynian in the south. The values suggest average crustal thicknesses of between 32 and 36 km during late Carboniferous time. For the Saar Nahe Basin, values between 50 and 75 mW/m 2 represent the thermal regime in the upper crust during the late Stephanian and early Permian time. Estimated eroded thicknesses of Palaeozoic sediments vary between 2500 m in the northern and central Ruhr Basin and more than 6000 m in the Osteifel and the Siegen Anticline within the Rheno-Hercynian, and between 1800 and 3600 m in the Saar Nahe Basin. Fission-track data provide evidence for significant reheating during the Mesozoic era within the entire study area. This phase of heating, probably linked to North Atlantic rifting, coincides with post-Variscan ore formation and with major tectono-magmatic events in central Europe.

No abstract

Traditional structural analysis in fold and thrust belts has focused on quantifying horizontal movements. In this paper, the importance of quantifying vertical movements is illustrated using a case study from Kurdistan, northern Iraq. The subsidence history of this area can be determined by analysis of the stratigraphic record from deep exploration wells. A phase of thermal subsidence from Middle Permian to Late Cretaceous (tectonic subsidence 1.8-1.9 km) was followed by flexural subsidence in the Late Cretaceous and Cenozoic (tectonic subsidence >0.6 km) in response to the closure of the Neo-Tethys Ocean. The main phase of continental collision during the Neogene resulted in the development of the Zagros fold and thrust belt; the amount of uplift at individual anticlines can be estimated from their amplitude (up to 3 km), but regional cross-sections indicate that approximately 1 km of additional basement-involved uplift is present NE of the Mountain Front. The timing of basement-involved uplift is interpreted to be coeval with the deposition of a Pliocene-Quaternary growth sequence adjacent to the Mountain Front. The amount of erosion resulting from the uplift can be estimated from vitrinite reflectance and cross-sections; these estimates show a similar pattern, with maximum erosion in the mountains NE of the Mountain Front (>1.5 km) and lesser erosion in the adjacent foreland basin (generally <0.8 km). The results provide a quantitative understanding of subsidence, uplift and erosion, and have been used to define prospective and high-risk areas for petroleum exploration.